User manual SIEMENS EUROSET 5020

[. . . ] KG (SHC), which in turn continued the Gigaset business of Siemens AG. Any statements made by Siemens AG or SHC that are found in the user guides should therefore be understood as statements of Gigaset Communications GmbH. Telephone locked When trying to connect: telephone locked 0­9 Phone number With tone dialling: n ­ * key pressed ­ # key pressed With additional services from public network providers: New call in calls list (Flashing) A new message has arrived ë Call waiting TM Call forwarding immediately ~ Call forwarding on no reply -- Call forwarding when busy s Anonymous call on 5 4 3 2 When installing, connecting and operating the telephone, always observe the following precautions: Only use the plugs and leads supplied. Only connect the connecting lead to the socket/jack provided for that purpose. [. . . ] GB When the telephone is locked, you will see { in the display. If you are using your telephone on a PABX, you may have to save one or more external line prefixes. A dialling pause is set automatically with the external line prefixe. You can save up to three external line prefixes. If several external line prefixes are saved, these are displayed next to one another; the current external line prefixe to be edited flashes. If necessary, use the ; key to toggle between the external line prefixes displayed, to edit them as follows: To delete an external line prefix: ?To enter an external line prefixe: o Enter a one- to three-digit code. Enter additional external line prefixes: ;o Press the Redial key, enter next external line prefixe. The telephone can display the approximate call duration in the display (up to 99 min. If the call duration display is activated, the time display begins 8 seconds after the last digit is dialled. If necessary, the pause time of the Pause key ; (pause function from second input position) can be changed to 1, 3 or 6 seconds (default setting: 3 seconds). During an external call, you can make a recall or divert the call. The subsequent procedure depends on your PABX. By default, the Recall key is preset to a flash time (interruption time) of 90 ms for use of new features on public telephone systems. With a connection to a PABX, it may be necessary to change the flash time (e. To do this, please refer to the operating instructions for your PABX. Changing dialling modes during a call If your telephone is set to pulse dialling and you want to use functions that require tone dialling (e. Remote access to an answering machine), you can change the dialling mode during a call. The telephone is reset to the original dialling mode by hanging up the handset. If the same subscriber calls more than once, a new entry is not created. up to 99 repeated calls are displayed in the additional information. Sequence of list entries: The most recent call is displayed in the first position (position number "01"). [. . . ] If your telephone is not working perfectly no signal tone: The tone volume might be set to 0. Lift handset, no dialling tone: Is the connecting lead correctly plugged into the telephone and the telephone socket?Dialling tone audible but telephone will not dial: The connection is OK. is the dialling mode set correctly (see page 5)? [. . . ]