User manual SIEMENS GIGASET A270

[. . . ] EN Dear Customer, Gigaset Communications GmbH is the legal successor to Siemens Home and Office Communication Devices GmbH & Co. KG (SHC), which in turn continued the Gigaset business of Siemens AG. Any statements made by Siemens AG or SHC that are found in the user guides should therefore be understood as statements of Gigaset Communications GmbH. Sehr geehrte Kundin, sehr geehrter Kunde, die Gigaset Communications GmbH ist Rechtsnachfolgerin der Siemens Home and Office Communication Devices GmbH & Co. [. . . ] Only use the mains unit supplied. Do not install the phone in a bathroom or shower room as the handset and base are not splash-proof. (page 7) Do not use the telephone in environments subject to explosion hazard (e. g. auto paint shops). $ If you give your Gigaset to someone else, make sure you also give them the operating manual. Fit only the approved rechargeable battery pack!Never use a conventional (non-rechargeable) battery pack as this could damage your health and cause injury. Use the battery pack as directed in these instructions (page 7). The operation of medical appliances may be affected. Be aware of the technical conditions within the particular environment (e. g. The handset may cause an intrusive 'hum' in hearing aids. Do not hold the handset against your ear while it is ringing (incoming call). Dispose of the battery pack and telephone in accordance with environmental regulations. Do not pollute the environment. Emergency numbers cannot be dialled if the keypad lock (page 2) is activated!Not all of the functions described in this manual are available in all countries. 2 Setting up the telephone for use Step 1: Connecting the base Step 3: Registering the handset to the base and charging the battery pack Place your handset in the base with the display facing forwards. The handset will now register automatically to the base. For procedure see page 4. Charging the battery pack 1 2 Connect the phone jack with the phone cord 1 and the mains units (230 V) with the power cord 2 as shown. The two cords must be plugged in at all times. Use only the mains unit supplied (see the bottom of the base). If you ever purchase another phone cord from a store, ensure that the phone conductors are correctly connected: 3-4 connection of the telephone conductors/EURO CTR37. To charge the battery pack, leave the handset in the base for approx. The charge status of the battery pack is correctly displayed only after uninterrupted charging/discharging. You should not therefore interrupt the charging process. Charging is electronically controlled to prevent overcharging. private phone numbers, prefixes of network providers etc. Press the h or C key to open the required list then press MENU. The following functions are available: EDIT ENTRY NEW ENTRY DISPLAY ENT DELETE Edit number and use to dial Save new phone number Show/edit number Delete a single entry h/C¢MENU¢L ¢OK. Storing a number in the directory/speed dial list Clear the list separately: Answering a call Your handset rings and you wish to take the call: Press the talk key c. [. . . ] 116 g NiMH 400mAh, 2xAAA Pack V30145-K1310-X383, A5B00075495685 400 mAh approx. 130 hours Questions and answers If you have any queries about the use of your phone, you can contact us any time at www. siemens. com/gigasetcustomercare. The table below contains a list of common problems and possible solutions. Problem Cause Solution Remark: The battery charging status is correctly displayed only after uninterrupted initial charging/discharging. Care Wipe the base station and handset with a damp cloth or an antistatic wipe. [. . . ]