User manual SIEMENS GIGASET AL14H

[. . . ] Do not install the phone in a bathroom or shower room. The handset and base station are not splashproof. Do not use your phone in environments with a potential explosion hazard (e. g. paint shops). $ Only use the approved, rechargeable battery pack, never a conventional (non-rechargeable) battery pack, as this could result in significant health risks and personal injury. [. . . ] Never use non-Gigaset battery chargers as this could damage the battery pack. Only place the handset in the charging cradle that is intended for it. * Gigaset Communications GmbH is a trademark licensee of Siemens AG. Place the battery leads in the lead guides so 3 On the handset ¢ ¢ ¢ PIN (default setting: 0000) ¢ OK. Registering flashes in the display. MENU Settings OK Handset OK Register HS Enter the base station system ¢ ¢ ¢ Making calls Making external calls and ending calls External calls are calls using the public telephone network. ~ (Enter the phone number) The number is dialled. (Or you can first press and hold c [dial tone] and then enter the number. ) During the call you can adjust the earpiece volume using t. End the call/cancel dialling: Press the end call key a. You can automatically insert a network provider dialling code before any phone number (see "Preselection" Menu tree, page 7). Registration takes approx. Please note: You can also automatically register the Gigaset AL13H handset to the Gigaset AL130/AL135 base station. Precondition: The handset is not registered to a base station. Place the handset in the charging cradle of the base station with its display facing forward. Leave the handset in the base station until it is registered. ¢c. Charging the battery pack Plug the mains unit for the charging cradle into the socket and place the handset in the charging cradle with the display facing forward. To charge the battery pack, leave the handset in the base station for approx. The charge status of the battery pack is only correctly displayed after uninterrupted charging/discharging. Therefore you should not interrupt the charging process. Charging is electronically controlled to prevent overcharging. The battery pack heats up during charging. After a while its charge capacity will decrease for technical reasons. You must set the date and time to ensure that the times of calls are logged correctly (see Menu tree page 7). Once the phone is registered and the time set, the idle display looks as shown on page 1. If you have any questions about using your phone, please read the tips on troubleshooting ("Questions and answers", page 6) or contact our customer service department (page 6). Accepting a call The handset indicates an incoming call by ringing and by a display on the screen. Press the talk key c to accept the call. When Auto Answer is activated (see Menu tree, page 7), simply remove the handset from the base station/charging cradle. Using the directory and lists Directory To open the directory: press h. You can save up to 40 phone numbers (max. [. . . ] Entries in the directory, the calls list and the handset's registration to the base station will be retained. MENU Settings OK Handset OK Reset Handset OK ¢ ¢ Cancel the reset with a. ¢ ¢ ¢ ¢ General specifications DECT standard GAP standard Range Base station power supply Environmental conditions in operation is supported is supported up to 300 m outdoors, up to 50 m indoors 230 V ~/50 Hz +5° C to +45 °C; 20% to 75% humidity 6 Care Wipe down the base station and handset with a damp cloth (no solvents) or an antistatic cloth. This can cause a build up of static. Service (Customer Care) We offer you support that is fast and tailored to your specific needs!Our Online Support on the Internet: www. gigaset. com/customercare For more information on aftersales service, please refer to your local warranty card. [. . . ]