User manual SIEMENS GIGASET DA310

[. . . ] u Protect your telephone from moisture, dust, corrosive liquids and vapours. u Do not touch the plug contact with pointed or metallic objects. u Do not carry the telephone by the leads. [. . . ] K Press the set key. Volume Melody 1 Melody 2 Melody 3 * and # are saved regardless of the set dialling mode but are only dialled with tone dialling mode ( page 4). If the number entered is longer than 21 digits, the saved number is deleted. Notes on saving and deleting programmable direct dial keys and speed dial numbers £ Dialling pauses One or more dialling pauses can be entered using I (not at 1st digit). Pauses are transferred to the memory and are necessary for certain extension systems (e. g. : 0 I 2368). u Dialling a dialling pause within the first 5 digits: The entire number saved is dialled, including the 2-second dialling pause. u Dialling a dialling pause after the first 5 digits: The portion of the number saved after the pause is only dialled after pressing the I key. 2 4 5 M N low medium 3 L O high Operation on a PABX Special functions/Recall key During an external call, you can make an enquiry or forward the call. The subsequent procedure depends on your PABX. To set the recall key, the telephone’s flash time must be set consistent with your PABX. Please refer to the operating instructions for your PABX. Adjusting the telephone Setting the handset volume The handset volume can be set to two levels. The primary volume is reset after hanging up. Changing the dialling mode/ flash time The telephone supports the following dialling modes: T2: Tone dialling, flash time 280/ 600 ms (depending on device model) Mute You can deactivate the telephone's microphone during a call. T1: Tone dialling, flash time 100 ms P: Pulse dialling Gigaset DA310 /IM-MEA en / A30054-M6528-A601-1-UZ19 / DA310_en. fm / 03. 08. 2011 5 en Depending on your PABX, you may need to change your telephone’s dialling mode or the flash time. To do this, use the sliding switch on the underside of the device. Appendix Care Wipe the unit with a damp cloth or an antistatic cloth. Do not use solvents or microfibre cloths. Never use a dry cloth; this can cause static. Temporary tone dialling switching in "Pulse" position To use functions that require tone dialling (e. g. remote control of answering machine), you can set the telephone to tone dialling for the duration of the call without adjusting the switch. After the connection is established: * Press the star key. After the connection is broken, the setting reverts to pulse dialling. Contact with liquid ! If the device comes into contact with liquid: 1 Allow the liquid to drain from the device. Place the device (the keypad facing down) in a dry, warm place for at least 72 hours (not in a microwave, oven etc. ). [. . . ] For further information on disposing of your used equipment, please contact your local authority or your refuse collection service. Authorisation This device is intended for connection to analogue networks outside the European Economic Area (with the exception of Switzerland) depending on national type approval. Country-specific requirements have been taken into consideration. We, Gigaset Communications GmbH, declare that this device meets the essential requirements and other relevant regulations laid down in Directive 1999/5/CE. [. . . ]