User manual SIEMENS GIGASET S450

[. . . ] KG (SHC), which in turn continued the Gigaset business of Siemens AG. Any statements made by Siemens AG or SHC that are found in the user guides should therefore be understood as statements of Gigaset Communications GmbH. 1 Display in idle status 2 Charge status of the batteries = e V U (flat to full) = flashes: batteries almost flat e V U flashes: batteries charging 3 Display keys (page 12) 4 Message key Access to calls and message lists; Flashes: new message or new call. 5 End call key, On/Off key End call, cancel function, go back one menu level (press briefly), back to idle status (press and hold), activate/deactivate handset (press and hold in idle status) 6 Hash key Key lock on/off (press and hold in idle status), Toggle between upper/lower case and digits 7 Call-by-call list key Open call-by-call list 8 Connection socket for headset 9 Microphone 10 Recall key - Confer (Flash) - Insert a dialling pause (press and hold) 11 Star key Ringtones on/off (press and hold), Open table of special characters 12 Key 1 Select network mailbox (press and hold) 13 Talk key Answer a call, open last number redial list (press briefly), start dialling (press and hold) 14 Handsfree key Switch between earpiece and handsfree mode; Lights up: handsfree activated; Flashes: incoming call 15 Control key (page 13) 16 Signal strength Ð i Ñ Ò (high to low) | flashes: no reception 4 Gigaset S450 ­ more than just a telephone . [. . . ] sMS: Press the display key §Edit§. Enter the number of the SMS service and insert a star if your service provider supports personal mailboxes. e-mail: Press the display key §Edit§. ¤ You should find out about the services Ask your service provider for details of how you should enter service numbers if you wish to use personal mailboxes (requirement: your service provider supports this function). Sending an SMS through another SMS centre This setting only applies to the SMS that is being sent next. The CLIP of the phone number for the SMS centre is evaluated in your Gigaset. U If required, you must prefix the number for the SMS centre with the access code (depending on your PABX). By sending a text message to your own number: once with and once without the access code. U When you send SMS messages, your sender number may be sent without your extension number. In this case the recipient cannot reply to you directly. Sending and receiving SMS on ISDN PABXs is only possible via the MSN number assigned to your base station. U You can only receive an SMS when the You have not requested the CLIP service (Calling Line Identification Presentation). Ask your service provider to enable this service. When you switch off you cannot send or receive any SMS with your phone. The settings which you have made for sending and receiving SMS (e. The call numbers of the SMS centres) and the entries in the incoming and draft message lists are saved when you switch off your phone. No number or an invalid number is entered for the SMS centre activated as the send centre. You receive a message whose text is incomplete. You have changed the ID of your mailbox. Tell your SMS contacts your new ID or undo the change (page 28). Call diversion is activated with When: All Calls or the call diversion All Calls is activated for the network mailbox. The "display call number" service is not activated. [. . . ] You can call up the table of special characters when writing an SMS using the * key. Select the required character and insert it with §Insert§. Press the hash key # briefly to switch from "Abc" mode to "123" and from "123" to "abc" and from "abc" to "Abc" (upper case: 1st letter upper case, all others lower case). Press the hash key # before entering the letter. [. . . ]