User manual SIEMENS GIGASET S79H

[. . . ] S79 H Gigaset Communications GmbH Frankenstr. 2a, D-46395 Bocholt Manufactured by Gigaset Communications GmbH under trademark license of Siemens AG. 2011 Gigaset products bearing the trademark 'Siemens' will exclusively use the trademark 'Gigaset'. Gigaset Communications GmbH 2010 All rights reserved. [. . . ] The most recent entry is at the head of the list. Open the list by selecting the message key f ( page 32) or via the menu: v Missed Alarms Select appointment/anniversary. Information about the appointment/anniversary is displayed. A missed appointment is displayed with the appointment name and a missed anniversary is displayed with the last name and first name. If ten entries are already stored in the list, the next appointment reminder will delete the oldest entry. Setting the Alarm Clock Prerequisite: The date and time have already been set ( page 13). v Alarm Clock You can enter data in the following fields: Activation: Select On or Off. Time: Enter the wake-up time in 4-digit format. How often: Select Daily or Monday-Friday. In idle status, the icon and wake-up time are displayed. A wake-up call is signalled on the display and with the selected ringtone ( page 3). If no key is pressed, the wake-up call is repeated twice at five minute intervals and then switched off. While the wake-up call sounds, you can permanently change the volume by pressing the side keys (louder) or (quieter). During a call, the wake-up call is only signalled by a short tone. Activating/deactivating the Alarm Clock and setting the wake-up time 37 Using a handset as a Room Monitor Deactivating the wake-up call/ repeating after a pause (Snooze mode) Prerequisite: A wake-up call is sounding. or Snooze Press the display key or any key. The wake-up call is deactivated and then repeated after 5 minutes. After the second repetition the wake-up call is deactivated completely. If you accept an incoming call, the Room Monitor is suspended for the duration of the call, but the function remains activated. If you deactivate then reactivate the handset, the Room Monitor remains activated. u Always check the operation of the Warning! Using a handset as a Room Monitor If the Room Monitor is activated, a previously saved destination number is called as soon as a set noise level is reached. You can save an internal or external number in your handset as the destination number. All of the handset keys are deactivated, with the exception of the display keys. The Room Monitor call to an external number is terminated after approximately 90 seconds. The Room Monitor call to an internal number (handset) is terminated after approximately 3 minutes (depending on the base). When the Room Monitor is activated, all keys are locked except the end call key. When the Room Monitor is activated, incoming calls to the handset are indicated without a ringtone and are only shown on the screen. [. . . ] Complete the firmware update as described. 54 Accessing additional functions via the PC interface If the update procedure fails several times or you can no longer connect to the PC, proceed as follows (emergency update): Close the "Gigaset QuickSync" program on the PC. Remove the USB data cable from the telephone. Press and hold keys 4 and L with the index and middle finger. Replace the battery. The message key f and the talk key c will flash alternately. [. . . ]