User manual SIEMENS GIGASET SL37

[. . . ] s Issued by Gigaset Communications GmbH Schlavenhorst 66, D-46395 Bocholt Gigaset Communications GmbH is a trademark licensee of Siemens AG Gigaset Communications GmbH 2008 All rights reserved. www. gigaset. com Gigaset SL37H Gigaset Handset at a glance 17 16 INT 1 V 1 2 15. 11. 07 ? 09:45 SMS 3 15 14 13 12 4 5 11 10 9 8 6 7 Please note: Illustration of handset on a base station with SMS functionality. 1 Display (screen) in idle status 2 Charge status of the battery pack = e V U (flat to full) = flashes: battery pack almost flat e V U flashes: battery pack charging 3 Display keys (page 9) 4 Message key Access to calls and message lists; Flashes: new message or new call 5 End call key, On/Off key End call, cancel function, go back one menu level (press briefly), back to idle status (press and hold), activate/deactivate handset (press and hold in idle status) 6 Hash key Keypad lock on/off (press and hold in idle status), Toggle between upper/lower case and digits (press and hold) 7 Call-by-call list key Open call-by-call list 8 Connection socket for headset and PC interface 9 Microphone 10 Recall key - Consult (flash) - Insert a dialling pause (press and hold) 11 Star key Ringer tones on/off (press and hold), With an open connection: switch between dial pulsing/touch tone dialling (press briefly), Open special characters table 12 Key 1 Select answer machine (depending on the base station)/network mailbox (press and hold) 13 Talk key Answer a call, open last number redial list (press briefly), start dialling (press and hold) When writing an SMS: send SMS 14 Handsfree key Switch between earpiece and handsfree mode; Lights up: handsfree activated; Flashes: incoming call 15 Control key (page 8) 16 Bluetooth activated (page 26) 17 Signal strength i (high to low) | flashes: no reception 1 Contents Contents Handset at a glance . 3 Gigaset SL37H More than just a telephone . Installing the base station and charging cradle . [. . . ] Proceed as is described when first assigning the key with a shortcut (page 18). Press and hold the left or right display Setting the screensaver You can set a picture from the Resource Dir. (page 22) to be displayed as a screensaver when the handset is in idle status. This will replace the idle status display. The screensaver is not displayed in certain situations, e. g. during a call or if the handset is de-registered. If a screensaver is activated, the Screen Saver menu option is marked with . 19 Digit key Change Press the digit key briefly. The list of possible key assignments is displayed. Proceed as is described when first assigning the key with a shortcut (page 18). First steps w Display Screen Saver The current setting is displayed. Change multiple line input: Activation: Select On (screensaver is displayed) or Off (no screensaver). Selection: If required, change the screensaver (see below). If the screensaver conceals the display, briefly press a or w to show the idle display with time and date. Activating/deactivating auto answer If you activate this function, when you receive a call you can simply lift the handset out of the charging cradle without having to press the talk key c. w Handset Auto Answer Select and press OK ( = on). a Press and hold (idle status). Changing the screensaver w Display Screen Saver s Scroll to the Selection line. s Select screensaver and press Changing the handsfree/ earpiece volume You can set the loudspeaker volume for handsfree talking to five different levels and the earpiece volume to three different levels. In idle status: t Handset Volume r Set the earpiece volume. Save Press display key if necessary to save the setting. Setting the volume during a call: t Press the control key. The setting will automatically be saved after approx. 3 seconds or press the display key Save. If t is assigned with another function, e. g. Configure setting (see above). Save changes: (page 31). Setting the display backlight Regardless of whether or not the handset is in the charging cradle, you can activate or deactivate the backlighting. [. . . ] During this time the keypad is disabled, and incoming calls will be ignored. Please note: If Bluetooth is activated and accessories (e. g. data cables page 33) are plugged into the connection socket (page 1), Bluetooth is automatically deactivated. If a Bluetooth voice connection has already been established, Bluetooth is not deactivated until it is ended. If a Bluetooth data connection has already been established, the response depends on the receiving device. [. . . ]