User manual SIEMENS GIGASET SL400H

[. . . ] SL400 H Gigaset Communications GmbH Frankenstr. 2a, D-46395 Bocholt Manufactured by Gigaset Communications GmbH under trademark license of Siemens AG. 2011 Gigaset products bearing the trademark 'Siemens' will exclusively use the trademark 'Gigaset'. Gigaset Communications GmbH 2010 All rights reserved. [. . . ] In idle status, the destination number or the internal destination number is displayed. Sensitivity: Select noise level sensitivity (Low or High). Press Save to save the settings. Activating the room monitor and entering the destination number 24 Using Bluetooth devices Changing the set destination number v Room Monitor Enter and save number as described in "Activating the room monitor and entering the destination number" ( page 24). To use the phone numbers, dialling codes (country and area code) must be stored in the directory ( page 31). You will find a description of how to operate your Bluetooth devices in the user guides for these devices. Cancelling/deactivating the room monitor Activating/deactivating Bluetooth mode v Activation Press Change to activate or deactivate Bluetooth mode ( = activated). Press the end call key a to cancel the call when the room monitor is activated. In idle status, press the display key Off to deactivate room monitor mode. Registering Bluetooth devices The distance between the handset in Bluetooth mode and the activated Bluetooth device (headset or data device) should be no more than 10 m. u If you register a headset, any headset Deactivating the room monitor remotely Prerequisites: The phone must support tone dialling and the room monitor should be set for an external destination number. Accept the call from the room monitor and press keys 9 ;. The room monitor function will deactivate after the call ends. There are no further room monitor calls. The other room monitor settings on the handset (e. g. , no ringtone) will remain activated until you press the display key Off on the handset. To reactivate the room function with the same phone number: Reactivate and save with Save ( page 24). Please note that is already registered will be overwritten. u If you would like to use a headset with your handset that is already registered to another device (e. g. , to a mobile phone), please deactivate this connection before you start the registration process. v Search for Headset/Search Data Device The search can take up to 30 seconds. Once the device has been found, its name is shown on the display. ~ Enter the PIN for the Bluetooth device you want to register and press OK. The device is saved in the list of known devices. Using Bluetooth devices Before you can use your Bluetooth device, activate Bluetooth, ensure the devices are visible and then register the handset. You can register one Bluetooth headset to the handset. You can also register up to five data devices (PCs, PDAs and mobile phones) to send and receive directory entries as vCards or exchange data with the computer ( page 37). 25 Using Bluetooth devices Cancelling/repeating current search To cancel search: Cancel Press the display key. Repeat search if necessary: Options Press the display key. Repeat Search Select and press OK. Rejecting/accepting an unregistered Bluetooth device If a Bluetooth device that is not registered in the list of known devices tries to connect with the handset, you will be prompted on the display to enter the PIN for the Bluetooth device (bonding). u Reject a Briefly press the end call key. u Accept ~ Enter the PIN for the Bluetooth device you want to accept and press OK. If you have accepted the device, you can use it temporarily (i. e. , as long as it is within receiving range or until you deactivate the handset) or save it to the list of known devices. [. . . ] The amount of time this takes is dependent on the speed of your Internet connection. The display on your phone is switched off and the message key f and the talk key c start flashing. Once the update is complete, your phone will automatically restart. Connect your phone to your PC using a Replace the battery. The message key f and the talk key c will flash alternately. [. . . ]