User manual SIEMENS GIGASET SX100 ISDN

[. . . ] s Be inspired The handset at a glance The handset at a glance Reception strength Talk key Answer a call Initiate dialling Switch from handsfree to "earpiece" mode Control key Opens the menu, directory, internal list, voice selection. Navigation in the input field Handsfree key Switch from "earpiece" to handsfree mode Lights up: Handsfree is activated Flashes: incoming call, automatic last number redial Key 1 Answering machine (hold down) Star key Ringer on/off (press for Charge status = flat U fully charged = flashes: battery is almost flat or is charging Current functions and display keys The display keys give you access to the functions shown in the display. End call key, On/Off key End call Cancel function Return to idle status (hold down) Handset on/off (in idle status, hold down) Internal 11 20. 09. 03 V 09:45 SMS Message key Access to SMS, calls approx. 2 seconds) list, answering machine (on SX150isdn) Flashes: new SMS, calls, messages Microphone Hash key Keypad lock on/off (hold down) Toggles between upper/ lower case and digits Recall key Initiate enquiry call Speed dial list key Open the speed dial list 1 The handset at a glance . [. . . ] The procedures for both types of remote operation are the same except for the initial start. Prerequisite: Remote operation from an external connection can only be used if you have defined an AB PIN (page 93). The AB PIN must always be given when operating remotely. In order to be able to fully use an answering machine externally (changing settings, deleting messages), you must enable the remote operation and remote deletion (see below). Instruction for remote operation If a function requires two keys, they must be pressed within 4 seconds. Otherwise, the entry is cancelled or only the function of the second key is carried out. If you press the wrong key, you can cancel it with E Spoken instructions are available for a few functions, activated by pressing the following keys. 0; Help with deleting Help with new messages/phrases Help with recording Help with operating modes :; F; 9; 85 Using the answering machine (on SX150isdn) Enabling remote operation and remote deletion By factory default, remote operation and remote deletion are deactivated. The setting must be performed for each of the three answering machines to be used remotely. Prerequisite: You have selected an answering machine (page 76). s s Settings Remote options OK OK Select the menu item and confirm. Set the remote operation: Select the menu item and confirm ( = is activated). If necessary, set the remote deletion: Select the menu item and confirm ( = is activated). Remote control OK s Remote delete OK Introduction to remote operation while you are away from home Remote operation requires a telephone capable of sending DTMF characters (tone dialling). It is important to enter the AB PIN immediately while the announcement text is being played. Remote control and, if necessary, Remote delete must be activated. ~ ~ Dial your own phone number. Enter the AB PIN immediately after the announcement begins. If the AB PIN is entered three times incorrectly in succession, the connection is interrupted. Afterwards, you can use the answering machine using key commands (page 87). Introduction to remote operation from a handset (internal) Comfort and standard handset [RRRRRRRRRRRRRRRRRRRRRRRRRRR] INT Press the display key. Enter the internal phone number for the answering machine: 91 for AB1, 92 for AB2 or 93 for AB3. If AB block is set (page 93), enter the AB PIN. ~ ~ Handset from another manufacturer (GAP mode) Lift the handset and if necessary, press another key to initiate an internal call. ~ ~ Enter the internal phone number of the answering machine: 91 for AB1, 92 for AB2 or 93 for AB3. If AB block is set (page 93), enter the AB PIN. 86 Using the answering machine (on SX150isdn) Wireless telephone adapter and normal telephone The automatic line seizure must be deactivated. By factory default, the automatic line seizure is activated!Lift handset and then: ~ ~ Enter the internal phone number for the answering machine: 91 for AB1, 92 for AB2 or 93 for AB3. If AB block is set (page 93), enter the AB PIN. Key sequence for remote operation After beginning remote operation for the answering machine, the functions of the keys for all telephones are the same. [. . . ] 35 Phone numbers in the speed dial list 35 SMS. 12 Sending Directory entry to a handset . 55, 60, 62 SMS in the outgoing message list. 139 Noise level in room monitor mode 100 Outgoing MSN . [. . . ]