User manual SIEMENS GIGASET USB ADAPTER DECT

[. . . ] EN Dear Customer, Gigaset Communications GmbH is the legal successor to Siemens Home and Office Communication Devices GmbH & Co. KG (SHC), which in turn continued the Gigaset business of Siemens AG. Any statements made by Siemens AG or SHC that are found in the user guides should therefore be understood as statements of Gigaset Communications GmbH. Sehr geehrte Kundin, sehr geehrter Kunde, die Gigaset Communications GmbH ist Rechtsnachfolgerin der Siemens Home and Office Communication Devices GmbH & Co. [. . . ] After the USB Adapter has been installed, the wizard will install the software for your base station and any additional software required. ì Confirm successful installation with Close. ì Depending on the operating system, you may be prompted to reboot your PC. i If you want to install Acrobat® Reader, cancel automatic reboot, install Acrobat® Reader, and then reboot the PC manually. Resetting the Gigaset USB Adapter If you have already started using the Gigaset USB Adapter, but now want to install it with a different base station, you should first reset the USB Adapter to its default settings. All the data and registrations you have changed or made will be deleted. ì Run the Gigaset USB Adapters configuration program: Start > Programs > Gigaset > Configuration of USB Adapter ì Select the Local adapter tab. ì Select Reset and confirm the warning prompt. ì You should also reset the registration of the registered partner stations. ì Close the configuration program. After resetting, you can reinstall the T-Sinus 721. Follow the instructions in Chapter "Installing the Gigaset USB Adapter DECT" on page 8. 10 Configuration Configuration Launching the configuration program The installation wizard opens the configuration program and takes over registration of your Gigaset USB Adapter. If you want to change the settings later on, run the configuration program. ì Select Start > Programs > Configuration of USB Adapter. It has four tabs where you can determine the settings for your Gigaset USB Adapter. Registering the Gigaset USB Adapter DECT with the base station i ì ì ì ì ì During initial installation, the installation wizard will guide you through the registration with the base station. To register the USB Adapter with a different base station: Open the Connection tab. The Status: section must display Configuration state. In the Registered %s bases section, choose a free registration location. Put your base station into registration mode (see the base station operating instructions). ì Enter the base station PIN (1­8 digits, factory setting 0000). The Gigaset USB Adapter will then register with your base station. After successful registration, you will find the name of your base station in the Registered %s bases field. For detailed explanations of the configuration program, please read the descriptions of the individual tabs. If registration is not possible, (base station not ready for registration or not connected to the power supply, wrong PIN), you will see a message indicating the cause of the problem. 11 Configuration Connection tab Connecting the Gigaset USB Adapters DECT to the PC Serial port: The Gigaset USB Adapter will look for a free COM port for connection. Manual changing of the setting is only necessary where several USB adapters are connected to the same PC/Laptop. [. . . ] u Changes to this guarantee require prior approval by Siemens in writing. 21 Guarantee period u The guarantee applies in countries in the EU from 1 January 2002 for a period of 24 months. u In all other countries the guarantee period shall be the relevant minimum statutory guarantee period, but no longer than 24 months. u The guarantee period starts on the day of purchase by the customer. u A successful claim under the guarantee does not extend the guarantee period. [. . . ]