User manual SIEMENS LB54564GB

[. . . ] Operating and installation instructions LB 23. . . LB 75. . . Operation Instructions Operating modes Exhaust-air mode: The extractor-hood fan extracts the kitchen vapours and conveys them through the grease filter into the atmosphere. The grease filter absorbs the solid particles in the kitchen vapours. The kitchen is kept almost free of grease and odours. [. . . ] Remove the wire grille and replace the filter mat. Removing and installing the grease filter Extractor hoods with a filter mat: 1. Rotate the handles on the left and right of the filter grille. 4. Install the filter frame in reverse sequence. The left and right sides of the filter frame must lock into position! 5 Filters and maintenance Extractor hoods with two filter cartridges: Warning: The halogen bulbs must be switched off and cool. Depress the detent on the grease filters in the direction of the arrow and fold down the grease filter slightly. Detach the grease filter by pulling it towards yourself. Activated carbon filter Removing and installing the activated carbon filter Extractor hoods with a filter mat: 1. The wire grille is no longer required when an activated carbon filter is installed. 2. Place the activated carbon filter on the filter mat and clamp it in. 2. Re-insert the clean grease filters. 3. 6 Activated carbon filter Extractor hoods with two filter cartridges: 1. Insert the screw through the wing nut and the sleeve and screw in the middle screw in the false bottom (required only during the initial installation). Screw, sleeve and wing nut are enclosed with the activated carbon filter. Using a screwdriver, press in the two lugs on the false bottom. If a spacer rail has been installed, it must be removed. Insert the activated carbon filter at the rear, fold up and lock in the middle with the wing nut. If the spacer rail has been removed, it must be re-installed. 4. Tape over the activated carbon filter with the enclosed sealing strip. 6. Removing the activated carbon filter: The activated carbon filter is removed in reverse sequence. Changing the activated carbon filter: If used normally (1 to 2 hours daily), the activated carbon filter should be changed approx. Activated carbon filters can be purchased from SPECIALIST OUTLETS (see optional accessories on the last page). Disposing of the old activated carbon filter: Activated carbon filters do not contain any pollutants. as residual waste. 7 Cleaning and care Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side. [. . . ] Attach the extraction pipe to the reducing connector. 150 mm l extraction pipe Attach the exhaust-air pipe directly to the air outlet. . If a one-way flap has been fitted, conduct a performance test. Extractor hoods with rectangular air outlet: Screw the enclosed air-pipe connector over the air outlet. Pipe connection Extractor hoods with 120 mm Ø air outlet: 100 mm Ø extraction pipe Insert the reducing connector (see optional accessories on the last page) into the air-pipe connector and then attach the exhaust-air pipe. [. . . ]