User manual SIEMENS LC654GA20B

[. . . ] Operating and installation instructions Fig. 550 2 Instructions for use: Operating modes Exhaust-air mode: The extractor-hood fan extracts the kitchen vapours and conveys them through the grease filter into the atmosphere. The grease filter absorbs the solid particles in the kitchen vapours. The kitchen is kept almost free of grease and odours. [. . . ] By doing so you will obtain maximum performance from your extractor hood. Disposing of the old activated carbon filter: There are no pollutants in the activated carbon filters. They can therefore be disposed of as part of your normal domestic refuse. 8 Cleaning and care Isolate the extractor hood by pulling out the mains plug or switching off the fuse. Do not clean the extractor hood with abrasive sponges or with cleaning agents which contain sand, soda, acid or chlorine! Clean the extractor hood with a hot soap solution or a mild window cleaner. Do not scrape off dried-on dirt but wipe off with a damp cloth. When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Do not use stainless-steel cleaner to clean the operating buttons. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. We recommend our stainless steel cleaner no. See enclosed service booklet for order address. Aluminium, coated and plastic surfaces: Do not use dry cloths. Do not use aggressive, acidic or caustic cleaners. Observe the warranty regulations in the enclosed service booklet. 9 Replacing the light bulbs Bulbs: 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Remove the grease filters (see Filters and Maintenance). Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. When switched on, the halogen bulbs become very hot. Even for some time after the bulbs have been switched off there is still a risk of burns. [. . . ] Using the template, mark positions on the wall for the screws. Ensure that the minimum distance between the hob and the extractor hood is maintained ­ 550 mm for an electric hob and 650 mm for a gas hob. The bottom edge of the template equates to the lower edge of the extractor hood. Drill 3x 8 mm holes for the extractor hood and 2x 8 mm holes for the fixing bracket for the flue duct and press in wall plugs flush with the wall. [. . . ]