User manual SIEMENS SBVPEM02

[. . . ] Operating instructions GVW696/P01 GVW697/P01 9000 407 132 (8906) 1 2 345 6 7 8 Start A B C 10 9 Reset 3 sec. 20 21 22 23 24 25 26 27 28 29 30 31 32 en Table of contents Washing the dishes . Optical display while the programme is running . 15 15 15 15 16 16 16 16 17 17 17 17 17 18 18 18 18 19 19 20 20 20 20 21 21 22 23 23 23 23 24 24 24 24 24 25 25 25 25 25 Safety instructions . 7 Switching off water softening system . [. . . ] ­ Close the door. Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press button P + until the digital display h jumps to : . ­ Press P + or ­ button until the displayed time corresponds with your requirements. ­ Press START button `, timer programming is activated. ­ To delete timer programming, press the P + or ­ button until h : is indicated on the digital display. You can change your programme selection at any time until the programme starts. End of programme The programme has ended when the value : is indicated on the numerical display h. The end of the programme is also indicated by an acoustic signal. This function can be changed as follows: ­ Open the door. ­ Hold down programme button # and press START button ` until : . . . . The LED for button # flashes and the digital display h displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display h. To change the setting, ­ Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). ­ Press START button `, the set value is saved. ­ Close the door. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display h. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 16 en Switching off the appliance Short time after the end of the programme: ­ Open the door. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. Changing the programme When the START button ` has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Open the door. ­ Hold down programme button # and press START button ` until : . . . . The LED for button # flashes and the digital display h displays the factory setting : . [. . . ] ­ Disconnect the appliance from the power supply. ­ Disconnect the waste water and fresh water connections. ­ Loosen the fastening screws under the worktop. ­ Pull out the appliance, carefully pulling the hose behind. 24 en Transportation Empty the dishwasher and secure loose parts. [. . . ]