User manual SIEMENS SC76M540EU/11 INSTALLATION INSTRUCTIONS

[. . . ] 8 Switching off rinse aid refill indicator . 14 3 en Safety instructions Delivery ­ Check the packaging and dishwasher immediately for damage caused in transit. Do not switch on a damaged appliance, but contact your supplier. ­ Please dispose of the packaging material in an environmentally friendly manner. [. . . ] The expected programme duration flashes on the digital display h. The programme starts running. ¿ Extra drying * An increased temperature during the final rinse and an extended drying phase ensure that even plastic parts dry better. There is a slight increase in the energy consumption. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display h. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 14 en Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press button 8 + until the digital display h jumps to : . ­ Press 8 + or ­ button until the displayed time corresponds with your requirements. ­ Press START button H, timer programming is activated. ­ To delete timer programming, press the 8 + or ­ button until h : is indicated on the digital display. You can change your programme selection at any time until the programme starts. Interrupting the programme ­ Switch off ON/OFF switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. ã=Warning Never use other chlorinated household detergents!Health hazard! Special salt and rinse aid ­ Check the refill indicators X and `. If required, refill salt and/or rinse aid. 16 en Filters The filters 1: keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. The filter system consists of a coarse filter, a flat fine filter and a microfilter. ­ After each washing cycle check the filters for residue. ­ Unscrew filter cylinder as illustrated and take out filter system. Spray arms Limescale and contaminants in the rinsing water may block nozzles and bearings on the spray arms 1* and 12. ­ Check outlet nozzles on the spray arms for blockages. ­ Remove the lower spray arm 12 upwards. ­ Clean spray arms under running water. ­ Re-engage or screw on spray arms. ­ Remove any residue and clean filters under running water. [. . . ] ­ Select programme with the highest temperature. The expected programme duration is indicated on the numerical display h. 4 minutes press the START button H until : is indicated on the digital display. 1 min : is indicated on the digital display . [. . . ]