User manual SIEMENS SF24261

[. . . ] Instructions for Use en 5600 053 338 (8212) en Index 4 6 6 7 8 9 10 Detergents . 12 14 15 17 18 21 21 22 Safety instructions . Getting to know your appliance Water softener . Filling the special salt container Filling the rinse-aid container Unsuitable dishes . [. . . ] A light barrier can detect dissolved food remnants in the water, e. g. The Aqua sensor is used according to the programme. When the Aqua sensor is active, "clean" rinsing water may be transferred into the next rinsing bath and/or the temperature adjusted. If the turbidity is greater, the water is drained and is replaced with fresh water. In this way the water consumption is reduced by approx. 4 litres for utensils which are "less" dirty. 15 en Time delay You can delay the start of the programme in 1-hour steps up to 19 hours. Press the timer programming button 4 until the digital display 3 jumps to . Keep pressing the timer programming button until the required time is displayed. To delete the timer programming, keep pressing the button until is displayed. You can change your programme selection at any time until the programme starts. Cancel programme (Reset) Only when the master switch is ON. Press the A and C buttons simultaneously, and hold them pressed for approx. When it has ended, set the main switch 1 to OFF. To restart the dishwasher, set main switch 1 to ON again and select desired programme. Remaining running time display When the appliance has started, the expected programme running time is displayed. The programmed running time is affected by the water temperature, the number of dishes, as well as the degree of soiling. If these conditions are changed, the running time (depending on the selected programme) can vary greatly. As the effect is not detected until a programme is running, the time may be longer or shorter than expected. Changing the programme It is possible to change the programme within 2 minutes after you have switched the dishwasher on. Should it be necessary to change the programme after this period, the programme cycle that has already been begun (e. g. washing) will be completed first of all. The new remaining time displayed is the sum of the remaining time from the preceding programme cycle and the remaining time attributable to the new programme that has been selected. Intensive drying If the "Intensive drying" function is activated, the temperature of the final rinse is increased in all programmes and you will therefore receive an improved drying result. (Note the higher temperature may not be suitable for fragile utensils. ) Hold down the programme button A and switch on the main switch. The digital display 3 flashes (on) (off). or To change the setting, press the programme button A . [. . . ] Water temperature: We recommend that you use cold water. If you do use hot water, the temperature should not exceed 60 °C. Transporting the dishwasher Drain water from the dishwasher. The appliance should only be transported in an upright position. If the appliance is not kept upright during transport, any water left inside may seep into the control module and cause subsequent errors with programme functions. [. . . ]