User manual SIEMENS SK76M530EU/07 INSTALLATION INSTRUCTIONS

[. . . ] 12 Switching off automatically after the end of the programme . 13 en Safety instructions Delivery ­ Check the packaging and dishwasher immediately for damage caused in transit. Do not switch on a damaged appliance, but contact your supplier. ­ Please dispose of the packaging material in an environmentally friendly manner. [. . . ] Automatic disconnection can be adjusted from : to : . : : : ­ ­ ­ ­ ­ Appliance does not switch off automatically Off after 1 min Off after 120 min Close the door. Hold down programme button # and press START button H until : . . . Press programme button # until the factory set value : is indicated on the digital display `. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display `. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 12 en To change the setting: ­ Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). The set value is saved. Changing the programme When the START button H has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Close the door. ­ Hold down programme button # and press START button H until the digital display ` : . . . To change the setting: ­ Press the button 3 to switch the Intensive drying on : or off : . Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. m Warning Rinse aid Never use other chlorinated household detergents!If required, refill rinse aid. ­ Remove any residue and clean filters under running water. ­ Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after closing the filter system. 14 en Spray arm Limescale and dirt from the rinsing water may block nozzles and the bearing assemblies of the spray arm 1". ­ Check outlet nozzles on the spray arm for blockages. ­ Remove the spray arm upwards. Troubleshooting The majority of faults which could occur in daily operation can be rectified by the user. This ensures that the appliance is quickly available for use again. The following overview will help you locating the causes and gives helpful advise to eliminate them. Note If the appliance stops during dishwashing or does not start for no obvious reason, first run the Abort programme function (Reset). (See chapter entitled "Dishwashing") ­ Clean the spray arm under running water. ­ Lock the spray arm into position. If on the digital display ` an error code (: to : ), always disconnect the appliance from the power supply and then turn off the tap. [. . . ] To change the setting: ­ By pressing the 3 button, you can switch the hot water setting off : or on : . The set value is saved. Removing the appliance Also observe the sequence of worksteps here. ­ Disconnect the appliance from the power supply. ­ Disconnect the waste water and fresh water connections. [. . . ]