User manual SIEMENS SN24D801EU/07 SHORT INSTRUCTIONS

[. . . ] 15 15 15 15 15 15 16 16 16 16 16 16 17 17 17 17 18 18 19 19 20 20 20 21 21 22 22 22 23 23 23 23 24 24 24 24 25 25 25 Safety instructions . Getting to know your appliance Control panel . Switching off salt refill indicator/ water softening system . Switching off rinse-aid refill indicator Utensils . [. . . ] If the Aqua sensor is active, "clean" rinsing water can be transferred to the next rinse bath and water consumption can be reduced by 3­6 litres. If the turbidity is greater, the water is drained and is replaced with fresh water. In the automatic programmes the temperature and running time can also be adjusted to the degree of soiling. Half load * If you have only a few items to wash (e. g. glasses, cups, plates), you can switch to "half load". It is recommended to put a little less detergent in the detergent dispenser than for a full load. Hygiene * The temperature is increased during the rinsing process. This additional option is ideal for cleaning e. g. chopping boards and baby bottles. Switching on the appliance Turn on the tap fully. The display of the last selected programme flashes. This programme remains selected if no other programme button 2 is pressed. The expected programme duration flashes on the digital display 10 . The programme starts running. IntensiveZone * Perfect for a mixed load. setting Press programme button A until the is indicated on factory set value the digital display 10 . To change the setting, Press the button C to switch intensive drying on or off . The set value is saved. Overall condition of the machine Check spray arm for grease and limescale deposits. If you find such deposits: Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Regularly clean door seal with a damp cloth. Never use a steam cleaner to clean your dishwasher. The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. [. . . ] 4 minutes press the START button 6 until is indicated on the digital display. Switch the appliance off 1 and turn the tap off. (This prevents residual water from running into the machine control and damaging the programme sequence). Removing the appliance Also observe the sequence of worksteps here. Disconnect the appliance from the power supply. [. . . ]