User manual SIEMENS SN24D801EU/10 SHORT INSTRUCTIONS

[. . . ] The LED for button A flashes and the factory set value of H:04 is indicated on the digital display ­ Press programme button C. Each time the button is pressed the set value increases by one setting; when the value reaches H:07, the display jumps back to H:00 (off). The chosen setting has now been stored. ABC Filling the salt dispenser Dissolves limescale (not necessary for set value 0 !) . . . Unscrew cover. [. . . ] Fill the salt dispenser with water before the first wash only. Wash immediately. Adding rinse aid Spick and span . . . Press mark 1, lift up cover 2. Refill if rinse-aid refill indicator is lit! Adding rinse aid. CLICK! Adding detergent A lot of dirt, a lot of detergent . . . If required, open the cover (press button). Attention Combination products are not suitable for all programmes, follow manufacturer's instructions. PLOP! Switching on the appliance Select programme 640 MA Quick, economical or intensive . . . Overview of programmes The max. possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the fascia. The programme data has been measured in the laboratory according to European standard EN 50242. Install supply hose without kinks. Display "E:24" and " " is lit Waste water hose is blocked or kinked Cover not attached to waste water pump Install waste water hose without kinks. Stains and streaks Clean waste-water pump (see above). Milky deposits on the utensils (can be removed) Rinse-aid dosage too high/too low Streaks: reduce dosage. Water or limescale stains: increase dosage. Display "E:25" and " " is lit Waste water pump blocked Water softening system incorrectly set; No salt Glasses not dishwasher-proof. Correctly set water softening system. Use a detergent suitable for glasses. Other fault display "E:XX" is lit Appliance has technical defect Call factory customer service (state fault display). Unplug appliance. Residual water in the appliance The programme has not yet ended Close and switch on the appliance or terminate the programme (see Terminating the programme). Milky deposits, glasses cloudy/tarnished (cannot be removed) Too little detergent. Hard knife blades are more susceptible Extraneous rust Use dishwasher-proof cutlery. Never wash rusting parts in the appliance. [. . . ] Hard knife blades are more susceptible Extraneous rust Use dishwasher-proof cutlery. Never wash rusting parts in the appliance. Plastic/utensils discoloured Discoloration caused by food colourings (tomato sauce) Follow manufacturer's instructions (detergent). [. . . ]