User manual SIEMENS SN26T890EP

[. . . ] 9000 404 737 (8811) en Instructions for use en Index 4 4 4 4 4 4 4 5 5 5 5 6 6 6 7 7 8 8 9 9 9 9 9 10 10 10 10 10 11 11 11 12 13 14 14 14 15 15 15 15 IntensiveZone . Remaining running time display Display window . Terminating the programme (Reset) Changing the programme . Overall condition of the machine Filters . [. . . ] Close the door. End of programme The programme has ended when the value is indicated on the numerical display 3 . The end of the programme is also indicated by an acoustic signal. This function can be changed as follows: Open the door. Hold down programme button A and press START button 10 until on the digital display is indicated. The LED for button A flashes and the digital display displays the factory . setting Press programme button A until the factory set value is indicated on the digital display . 16 en To change the setting, press programme button C . Each time the button is pressed, the set value increases by one level; when the has been reached, the value of (off). display jumps back to Press START button 10 , the set value is saved. Close the door. Terminating the programme (Reset) Open the door. is indicated on the digital display 3 (buzzer sounds). Close the door. Switching off the appliance Short time after the end of the programme: Open the door. Turn off the tap (not applicable if Aqua-Stop fitted). Remove the utensils when they have cooled down. Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Changing the programme When the START button 10 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) Open the door. Hold down programme button A and press START button 10 until on is indicated. the digital display Release both buttons. The LED for button A flashes and the digital display displays the factory . setting Press programme button A until the factory set value is indicated on the digital display 3 . To change the setting, Press the button C to switch or off . [. . . ] Pull out the appliance, carefully pulling the hose behind. Protection against frost If the appliance is in a room where there is a risk of frost (e. g. holiday home), empty the appliance completely (see Transportation). Turn off the tap, disconnect supply hose and drain water. 25 en Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. Please dispose of the individual parts separated according to type. [. . . ]