User manual SIEMENS SN65M009EU

[. . . ] SN… SX… en Table of contents Intended use . . 4 . 5 . 5 . 6 . 6 . 6 . 6 Loading the dishwasher . 20 Express Wash/ Speed Perfect (VarioSpeed). 9 Water softening system/ Special salt . [. . . ] Close the door. Switching off the appliance Short time after the end of the programme: 1. Turn off the tap (not applicable if Aqua-Stop fitted). Remove the utensils when they have cooled down. Note When the programme ends, leave the appliance to cool down a while before opening it. This will prevent steam from escaping and causing longterm damage to your built-in furniture. Terminatingtheprogram e Terminating the programme (Reset) 1. On the digital display h is indicated : . Close the door. Changing the programme When the START button ` has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). 24 Cleaning and maintenance en Intensive drying The final rinse uses a higher temperature which improves the drying result. Hold down programme button # and press START button ` until : . . . . The LED for button # flashes and the digital display h displays the factory setting : . Press programme button # until the factory set value : is indicated on the digital display h. Press the button 3 to switch the Intensive drying on : or off : . Close the door. Cleaning and maintenance gC ne i nl a d n a en cm nti aa e If you find such deposits: Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. To ensure that the door seal always remains clean and hygienic, regularly clean it with a damp cloth and a little washing-up liquid. If the appliance is switched off for a prolonged period, leave the door ajar to prevent the formation of an unpleasant odour. Never use a steam cleaner to clean your dishwasher. The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. m Warning – Health hazard Never use other domestic detergents, e. g. [. . . ] The LED for button # flashes and the digital display h displays the factory setting : . Press programme button # until the factory set value : is indicated on the digital display h. By pressing the 3 button, you can switch the hot water setting off : or on : . Close the door. 38 Installation and connection en Electrical connection Connect the appliance to an alternating current only, ranging from 220 V to 240 V and 50 Hz or 60 Hz via a correctly installed socket with protective earth conductor. [. . . ]