User manual SIEMENS SN66M051EU

[. . . ] 9000 299 935 (8712-1) en Instructions for use en Index 4 4 4 4 4 4 4 5 5 5 5 6 6 7 7 7 8 8 8 9 9 9 9 9 9 10 10 10 10 11 12 12 14 14 14 15 15 15 15 15 15 Washing the dishes . Optical display while the programme is running . Remaining running time display Timer programming . Terminating the programme (Reset) Changing the programme . [. . . ] Press 6 + or ­ button until the displayed time corresponds with your requirements. Press START button 8 , timer programming is activated. To delete timer programming, press the 6 + or ­ button until is indicated on the digital display. You can change your programme selection at any time until the programme starts. Close the door. End of programme The programme has ended when the value is indicated on the numerical display 9 . The end of the programme is also indicated by an acoustic signal. This function can be changed as follows: Open the door. Hold down programme button A and press START button 8 until on the digital display is indicated. The LED for button A flashes and the digital display displays the factory . setting Press programme button A until the factory set value is indicated on the digital display . Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display 9 . The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 16 en To change the setting, press programme button C . Each time the button is pressed, the set value increases by one level; when the has been reached, the value of (off). display jumps back to Press START button 8 , the set value is saved. Close the door. Terminating the programme (Reset) Open the door. is indicated on the digital display 9 (buzzer sounds). Close the door. Switching off the appliance Short time after the end of the programme: Open the door. Turn off the tap (not applicable if Aqua-Stop fitted). Remove the utensils when they have cooled down. Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Changing the programme When the START button 8 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) Open the door. [. . . ] Press the START button 8 until on the digital display is indicated . Switch off appliance 1 and turn off the tap. (This prevents residual water from running into the machine control and damaging the programme sequence). Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. Please dispose of the individual parts separated according to type. [. . . ]