User manual SIEMENS WAQ2441XEE

[. . . ] Safety instructions ­ The washing machine is heavy - take care when lifting. ­ Caution: frozen hoses may rip/burst. Do not install the washing machine in areas exposed to frost or outdoors. ­ The washing machine could be damaged. [. . . ] It is a prerequisite of all warranty claims that the appliance with Aqua-Stop must have been set up and connected correctly in accordance with our instructions; this also includes a correctly fitted Aqua-Stop extension (original accessories). Our warranty goes not cover defective power cables or fittings between the Aqua-Stop connection and the tap. Appliances with Aqua-Stop do not need to be supervised during operation, nor secured afterwards by turning off the tap. The tap only needs to be turned off if you are away from home for a long period, e. g. 60 x 55 x 85 cm 66 ­ 73 kg depending on model Nominal voltage 220-240 V, 50 Hz Nominal current 10 A Nominal power 2, 300 W 200-1000 kPa (2-10 bar) Installation instructions en Electrical connection The washing machine must only be connected to an alternating current via a properly installed earthed socket. After transportation, the transport braces must be removed. page 3. Contents Safety instructions . . To prevent unused detergent from flowing straight into the drain during the next wash: Pour 2 litres of water into compartment II and start the Empty programme. 9000502633 The power supply and voltage indicated on the washing machine (rating plate) must be the same. The connected load and fuse required are specified on the rating plate. Make sure that: ­ the mains plug fits the socket, ­ the cable cross-section is adequate, ­ the earthing system is properly installed. (If this is necessary), the mains cable may only be replaced by a qualified electrician. Replacement mains cables are available from the after-sales service. Do not use multiple plugs/couplings or extension cables. If a residual current circuit breaker is used, only use a type which displays this symbol: , . Only this symbol guarantees compliance with the currently applicable regulations. Do not plug in or unplug the mains plug with wet hands. Pull the appliance plug out of the socket at the plug only, not by the cable. Technical specifications Dimensions (width x depth x height) Weight Mains connection Page . . 7 9008 / 9000502633 Water pressure Read these instructions before switching on the washing machine. Also observe the separate Instruction manual. Keep all documents for use in the future or for the subsequent owner. Manufacturer ­> Operating instructions 5 6 7 Safety instructions ­ The washing machine is heavy - take care when lifting. ­ Caution: frozen hoses may rip/burst. Do not install the washing machine in areas exposed to frost or outdoors. ­ The washing machine could be damaged. Do not lift the appliance by protruding components (e. g. [. . . ] (If this is necessary), the mains cable may only be replaced by a qualified electrician. Replacement mains cables are available from the after-sales service. Do not use multiple plugs/couplings or extension cables. If a residual current circuit breaker is used, only use a type which displays this symbol: , . [. . . ]