User manual SIEMENS WD14H440

[. . . ] Safety instructions ­ The washer dryer is heavy ­ take care when lifting it. ­ Warning: frozen hoses may tear/burst. Do not install the washer dryer outdoors or in areas where there is a risk of frost. Do not lift by projecting components (e. g. [. . . ] ­ Warning: frozen hoses may tear/burst. Do not install the washer dryer outdoors or in areas where there is a risk of frost. Do not lift by projecting components (e. g. ­ In addition to the instructions mentioned here, special regulations of the relevant water and power supply companies may apply. ­ If in doubt, have the appliance connected by a technician. ­ Lay hoses and cables in such a way that there is no risk that they can be tripped over. Installation area ­ ­ ­ ­ Stability is important to prevent the machine from wandering. The installation area must be firm and level. Soft floors/floor coverings are not suitable. Ensure the area is well ventilated to achieve good drying performance. If installing the appliance on a pedestal ­ It is essential to secure the washer dryer feet with holding brackets *. If installing the appliance on a wooden joist floor ­ If possible, install the washer dryer in a corner. ­ Screw a water-resistant wooden panel (min. ­ It is essential to secure the washer dryer feet with holding brackets *. WMZ 2200, WX 9756 Environmental disposal ­ Dispose of packaging in an environmentally friendly manner. ­ This appliance has been identified in accordance with the European Directive 2002/96/EEC on Waste Electrical and Electronic Equipment (WEEE). The Directive specifies a framework for the return and recycling of waste appliances and is valid throughout Europe. Hose and cable lengths Connection on left side or Connection on right side Scope of delivery Aqua-Stop Aqua-Secure Humidity in the drum is caused by the final inspection. ~140 cm ~90 cm Standard max. 100 cm Water drainage Power cord Water supply ~95 cm ~160 cm ~140 cm ~165 cm min. 60 cm Note: if hose holders are used, the hose lengths may be reduced. Available from dealer/customer service: ­ Aqua-Stop extension hose **, approx. WMZ 2380, WZ 10130 Covers Hose holder Built-under/Built-in appliance Depending on the connection ­ A 24­40 mm dia. hose clip may also be required for connecting the siphon (available from specialist retailers). Page 4: Water connection Build-under/build-in before connection to the power supply. Useful tool ­ Spirit level for aligning the washer dryer. ­ Wrench for adjusting the machine feet. Installed in between kitchen units (built-under or built-in) ­ Dimension requirement of kitchen unit: a = 650 mm, b = 620 mm, c = 850 mm ­ Install washer dryer only under a continuous worktop that is connected firmly to the adjacent cupboards. ­ The installation area must be well ventilated, otherwise the washer dryer will operate below optimum performance. [. . . ] Place the air inlet filter back on and close. Attach the pump cap and screw it on tight until the stop, handle is upright. Place the drainage hose back in the retainer. Place the service flap back on and close. [. . . ]