User manual SIEMENS WDI1440

[. . . ] Instruction Manual and Installation Instructions en Wash & Dry Table of Contents Operating Instructions Information concerning waste disposal . Protection of the environment / Hints and tips . 5 5 5 6 7 7 7 8 8 9 10 11 11 13 13 14 17 19 19 21 22 23 23 28 28 28 30 30 31 32 33 34 35 2 End of programme . Cleaning and servicing the washer dryer . [. . . ] If the option LED lights, the display indicates the selected spin speed. i Drying times depend on the spin speed: the higher the speed the lower the drying time and, conse quently, the lower the power consumption. Choo se the highest spin speed compatible with the type of laundry. from 600 to 1400 rpm: from 600 to 900 rpm: Unbalanced load detection system The automatic unbalanced load detection system turns round the laundry several times to ensure even distribution. If the laundry is very unevenly distributed, the final speed is reduced or there is no spin cycle for reasons of safety. 31 Washing and drying This washer dryer allows - wash only - dry only - wash+dry programmes to be set. In the wash+dry programmes, the cycle shifts auto matically from washing to drying without having to touch the controls to continue the cycle after washing. Opening the door Loading the washer dryer q Press the Door button to open the door. Laundry items which have been pretreated with deter gents containing solvents, e. g. stain remover or clea ner's solvent, must be rinsed out thoroughly by hand before they are placed in the washer dryer, otherwise there is a risk of explosion!Warning Before loading the washer dryer, ensure that no foreign matter or pets are in the drum. q Place the laundry loosely and unfolded in the drum. q Please observe the maximum drum loads for the different wash and drying programmes, pages 23 and 24. q Ensure that no items of laundry are jammed between the door and the rubber seal. q Close the door by pressing it shut until it engages audibly. q Measure and fill detergent for wash only or wash+dry programmes. q Open the water tap. 32 Wash only q Set the programme selector to the required programme, e. g. The display alternates between the remaining time and the spin speed setting. q Select the required spin speed, page 31. q Select additional functions for individual programmes, e. g. The remaining time appears in the display. The washing programme starts Pausing the washing programme i Washing programmes can be paused at any time during the cycle. q Press the Start/Stop button for approx. The display alternates between STOP and ---. [. . . ] 9 bars) (when the tap is turned on, at least 8 litres of water is discharged per minute). - A pressure reducing valve must be installed if the maximum water pressure is exceeded. q Connect the water supply hose to the tap. i In the case of a defective Aquasure hose (water supply hose), the check eye 1 is red, for fault report, page 42. [. . . ]