User manual SIEMENS WDI1440EE

[. . . ] Instruction Manual and Installation Instructions en Wash & Dry Table of Contents Operating Instructions Information concerning waste disposal . Protection of the environment / Hints and tips . 5 5 5 6 7 7 7 8 8 9 10 11 11 13 13 14 17 19 19 21 22 23 23 28 28 28 30 31 32 33 34 36 2 End of programme . Cleaning and servicing the washer dryer . [. . . ] i Drying times depend on the spin speed: the higher the speed the lower the drying time and, conse quently, the lower the power consumption. Choo se the highest spin speed compatible with the type of laundry. from 600 to 1600 rpm: from 600 to 900 rpm: Unbalanced load detection system The automatic unbalanced load detection system turns round the laundry several times to ensure even distribution. If the laundry is very unevenly distributed, the final speed is reduced or there is no spin cycle for reasons of safety. 31 Washing and drying This washer dryer allows - wash only - dry only - wash+dry programmes to be set. In the wash+dry programmes, the cycle shifts auto matically from washing to drying without having to touch the controls to continue the cycle after washing. Opening the door Loading the washer dryer q Press the h door button to open the door. Laundry items which have been pretreated with deter gents containing solvents, e. g. stain remover or clea ner's solvent, must be rinsed out thoroughly by hand before they are placed in the washer dryer, otherwise there is a risk of explosion!Warning Before loading the washer dryer, ensure that no foreign matter or pets are in the drum. q Place the laundry loosely and unfolded in the drum. q Please observe the maximum drum loads for the different wash and drying programmes, pages 23 and 24. q Ensure that no items of laundry are jammed between the door and the rubber seal. q Close the door by pressing it shut until it engages audibly. q Measure and fill detergent for wash only or wash+dry programmes. q Open the water tap. 32 Wash only Programmes q Set the programme selector to the required pro gramme, e. g. First the display shows a rotated digit and then it alter nates between showing the remaining time and the active spin speed. q Select the required spin speed, page 31. q Select additional functions to cope with special situations, e. g. The washing cycle starts. Interrupting washing programmes i Washing programmes may be interrupted at any time while they are running. The display alternates between STOP and ---. Resume the programme cycle from where it left off: q Press the M start button again. Changing washing programmes q Turn the programme selector without pausing the washer dryer first. The display alternates between STOP and ---. Start the new programme cycle: q Press the M start button. [. . . ] q Connect the water supply hose to the tap. i The check eye 1 will be red, if the aquasecure hose (water inlet hose) is damaged, errorcode page 42. After connecting the water inlet hose: q Turn on the tap fully. q Check the connection points for leaks. min. [. . . ]