User manual SIEMENS WDI1442EU

[. . . ] Instruction Manual and Installation Instructions en Wash & Dry Inhaltsverzeichnis Gebrauchsanleitung General safety instructions . Cleaning and servicing the washer dryer . 3 5 6 7 10 12 13 23 28 29 32 36 37 Aufstellanleitung Anhang Installing, connecting and transporting the washer dryer . . 38 44 2 Please read these operating and installation instruc tions and all other information enclosed with the was her dryer and act accordingly. [. . . ] q Place the laundry loosely and unfolded in the drum. q Please observe the maximum drum loads for the different wash and drying programmes, pages 8 and 9. q Ensure that no items of laundry are jammed between the door and the rubber seal. q Close the door by pressing it shut until it engages audibly. q Measure and fill detergent for wash only or wash+dry programmes. q Open the water tap. 23 Wash only q Set the programme selector to the required programme, e. g. The display alternates between the programme length and the spin speed. q Select the required spin speed, page 21. q Select additional functions for individual programmes, e. g. The remaining time appears in the display. The washing programme starts. Pausing the washing programme i Washing programmes can be paused at any time during the cycle. The display alternates between STOP and ---. Resuming the programme: Press the Start M button again. Stopping the washing programme Changing the washing programme Press the Start M button during the programme cycle and keep pressed until 0000 appears in the display (approx. q Select a new programme The display alternates between STOP and ---. Starting a new programme: Press the Start M button. i After a short delay, the duration of the new program me appears in the display. i If the detergent compartment already contains detergent, the new programme skips the fill phase. Selecting a new programme i After a programme has ended (display shows End) the washer dryer must first be switched off before a new programme can be selected. 24 Dry only i The tap must remain open during the drying cycle, as cold water is needed. i The maximum permitted load for drying is 2. 5 kg. i For hand washed items select a separate spin cycle. Setting a drying programme q Set the programme selector to dry Y. q Press the dry Y button repeatedly until the required drying time is set, page 20. q Press the delicate drying Z button to set low heat if desired, page 21. The remaining time appears in the display. Pausing the drying programme i The drying programme can be paused at any time during the cycle. [. . . ] q Connect the water supply hose to the tap. i In the case of a defective Aquasure hose (water supply hose), the check eye 1 is red, for fault report, page 32. After connecting the water inlet hose: q Turn on the tap fully. q Check the connection points for leaks. min. [. . . ]