User manual SIEMENS WK14D320GB

[. . . ] SIEMENS Installation and operating instructions en Washer-dryer Please read the Installation and operating instructions and all the other information supplied and handle the appliance accordingly. Keep all documents in a safe place for future reference, or to pass on to the next owner. For further information and a selection of our products, visit our website: www. siemens-home. com Table of contents Operating instructions General safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Environmental protection/economy tips . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] coins, paper clips, needles, nails) have caused rust spots: ­ Use a chlorine-free cleaning agent; observe the manufacturer's instructions. Never use steel wool. Detergent drawer If there are detergent or care product residues: Pull out the detergent drawer as far as the stop. Press on the zone labelled PUSH and take out the detergent drawer. Clean the detergent drawer guide in the washer-dryer. Remove the fabric softener compartment insert. Clean the detergent drawer and fabric softener compartment insert under running water. Insert the fabric softener compartment insert. Insert the detergent drawer. 17 Drain pump Turn the programme selector to Off. Use a screwdriver to release the lock pins. Tip the kick panel and pull upwards to remove. Draining the water Take the drain hose out of the retainer. Remove the plug from the drain hose and release the washing water. ­ The container for the drained water may have to be emptied several times. ­ When no more water runs out, replace the plug. Place the drain hose into the retainer. Cleaning the drain pump Unscrew the pump cover. ­ Clean the pump housing and remove any foreign objects. ­ Make sure that the impeller can turn freely. Replace the pump cover and screw firmly in place. Place the kick panel in the 4 clip-in slots and secure to the housing using the lock pins. Filter in the water supply hose If no water runs into the washer-dryer, or only an insufficient amount, you must first reduce the water pressure in the supply hose: Turn off the tap. Choose any programme (except Rinse + Spin / Empty + Spin). Allow the programme to run for approximately 40 seconds. Unscrew the water supply hose from the tap. Check whether water comes out of the end of the hose. [. . . ] 25 -Drying options . . . . . . . . . . . . . . . . . . . 14 -Detergent . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Transport safety bolts . . . . . . . . . . . . . 24 Housing Pre-wash -Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 -Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Prewash . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Unbalanced load detection Programme -Cancelling . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]