User manual SIEMENS WK14D540EU

[. . . ] SIEMENS Installation and operating instructions en Washer-dryer Please read the Installation and operating instructions and all the other information supplied and handle the appliance accordingly. Keep all documents in a safe place for later use or to pass on to subsequent owners. For further information and a selection of our products, please see our website: www. siemens-home. com Contents Operation instructions General safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Environmental protection/economy tips . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] ­ B (Remaining time) is displayed on the display panel. The M (Programme start) symbol lights up. ­ The washing programme starts. i Drying only Turn the programme selector to the desired drying programme. ­ The display panel alternately shows B (Remaining time) and the recommended load in kg. Press the ^ (Drying) button to set the drying options ­> page 14 ­ If you do not make a selection, the e (Cupboard-dry) option is set. ­ Observe the maximum load, Programme table ­> page 30. ­ B (Remaining time) is shown on the display panel and the ^ (Drying) and M (Programme start) symbols light up. ­ The drying programme starts. i Washing and drying Successive washing and drying. Set the programme selector to the desired programme, e. g. ­ B (Remaining time) and the recommended load in kg appear alternately on the display panel. If necessary, adjust the temperature and the spin speed and select any options for your individualised programme ­> page 14. Press the ^ (Drying) button to set the drying options ­> page 15 Load the laundry ­> page 9. ­ Observe the maximum load, Programme table ­> page 30. Press the M (Start/Pause) button. i The drying programme that is carried out is automatically determined by the washing programme, see the Programme table ­> page 30. 16 End of the programme The washing and drying programmes are ended automatically. Leave the door open so that the inside of the washer-dryer can dry out. Turn off the tap (not necessary on models with Aqua-Stop). Rinse Hold If the spin function was deactivated at the start of the wash cycle, $ (no final spin = laundry remains in last rinsing water), the washing programme is automatically stopped after the final rinse. The display panel shows alternating with . In order to drain the rinsing water and, if required, spin the laundry: Press the B (Spin) button repeatedly until the required spin speed is set. The water is drained and the washer-dryer spins the laundry. The programme is completed when appears in the display field. The maximum spin speed depends on the selected wash programme. If you do not wish to spin the laundry: Press the B (Spin) button (remaining time for draining is displayed). [. . . ] ­ Height difference between the installation surface and the drain: max. Secure the connection with a 24-40 mm hose clamp (available from specialist retailers). 28 Electrical connection The washer-dryer must only be connected to an alternating current supply via a properly installed earthed socket. If a residual current circuit breaker is used, only use a type which displays this symbol: , . Only this symbol guarantees compliance with the currently applicable regulations. [. . . ]