User manual SIEMENS WM09E260HK

[. . . ] Do not connect to a mixer tap of a pressureless hot water heater. - If in doubt, have the appliance connected by a technician. Water supply 1. Take the hoses out of the holders and, depending on the model, remove the elbow. Do not: - kink, crush, modify or sever water supply hose (strength is no longer guaranteed). [. . . ] Check that the water is pumped out quickly enough. Installation area - Stability is important to prevent the machine from wandering!- The installation area must be firm and level. - Soft floors/floor coverings are not suitable. Drainage into a siphon: Secure connection point with hose clip, 24-40 mm (dealer). If installing the appliance on a base - Secure the washing machine feet with retention plates * (* order no. WMZ 2200, WX 9756) If installing the appliance on a wooden joist ceiling - If possible, install the washing machine in a corner. - Screw a water resistant wooden panel (min. - Secure the washing machine feet with retention plates * (*order no. see above). 1 2 3 4 Alignment Loud noise formation, intense vibrations and wandering" may be due to incorrect alignment! Transportation, e. g. if moving house After transporting and correctly installing and connecting the appliance, run the Drain b auxiliary programme before starting the first washing programme. Align washing machine with spirit level. 1. Loosen lock nut in a clockwise direction with a wrench. 1. Before transporting the washing machine: 2. Change height by rotating the appliance feet. All four appliance feet must be firmly on the floor. Check alignment of the washing machine with a spirit level and, if required, correct. 1. See operating instructions, page 9; Detergent solution pump. Release the water pressure in the supply hose. See operating instructions, page 9; Filter in the water supply. Isolate the washing machine from the power supply. Remove the hoses. Customer service F Before calling customer service, please check whether you can eliminate the fault yourself. See Operating instructions, page 10 «What to do if . . . ». F If you require advice, even during the warranty period, you will incur costs for the call out of a technician. can find your nearest service in Please give customer service F Youproduct number (E Nr. )customerproductionthe enclosed list. the appliance. the and the number (FD) of E Nr. + Washing machine en FD Product number Production number You can find the rating plate which contains this information in the frame of the open washing machine door and in the thick bordered box on the appliance rating plate at the back of the appliance. 2. 3. Tighten the lock nut against the housing. [. . . ] If a residual current operated circuit breaker is used, use only a type which features this symbol: 7 Only this symbol guarantees compliance with the currently valid regulations. Do not insert/pull out the plug with damp hands. Do not pull out the mains plug by tugging the power cord. Manufacturer (see Operating instructions) 0306/9000 145 679 Contents J J J J J J J J J J J J Page 1 1 2 2 3 4 5 5 6 6 7 7 Technical specifications Dimensions (width x depth x height) Weight Nominal voltage Mains connection Water pressure Waste water pipe 60 x 59 x 86 cm 73 kg depending on model 220-240 V, 50 Hz Socket (220-240 V, 50 Hz, min. [. . . ]