User manual SIEMENS WM09E360HK

[. . . ] - Attention: Operate the washing machine with cold drinking water only. Do not connect to a mixer tap of a pressureless hot water heater. Only use the inlet hose supplied or one which was purchased from an authorised specialist dealer. - If in doubt, have the appliance connected by a technician. Water supply Water supply hose: Attention: Do not kink, crush, modify or sever water supply hose (strength is no longer guaranteed). [. . . ] Drainage into a siphon: Attention: Secure connection point with hose clip, 24-40 mm (dealer). Depending on the connection - 1 hose clip 24-40 mm (specialist outlet) for connection of the siphon is also required -> page 4; Water connection. Built under appliance Risk of electric shock!- Instead of the appliance cover panel, have a technician install a sheet metal cover * (* order no. WMZ 2420, WZ 10190). Useful tool - Spirit level for alignment. Installation area - Stability is important to prevent the machine from wandering!- The installation area must be firm and level. - Soft floors/floor coverings are not suitable. If installing the appliance on a base - The feet of the appliance must be secured with holding brackets; order no. WMZ 2200, WX 9756, CZ110600, Z 7080X 0. If installing the appliance on a wooden joist - If possible, install the washing machine in a corner. - Screw a water resistant wooden panel (min. - The feet of the appliance must be secured with holding brackets; order no. see above. 1 2 3 4 Alignment Loud noise formation, intense vibrations and wandering" may be due to incorrect alignment! Transportation, e. g. if moving house 1. Before transporting the washing machine: Align washing machine with spirit level. 1. Loosen lock nut in a clockwise direction with a wrench. 2. Change height by rotating the appliance feet. All four appliance feet must be firmly on the floor. Check alignment of the washing machine with a spirit level and, if required, correct. 1. Release the water pressure in the supply hose. -> operating instructions, page 9; Filter in the water supply. -> operating instructions, page 9; Detergent solution pump. Isolate the washing machine from the power supply. Remove the hoses. Customer service customer service, please F Before callinginstructions, What to do if check whether you can eliminate the fault yourself. F If you require advice, even during the warranty period, you will incur costs for the call out of a technician. can find your nearest service in Please give customer service F Youproduct number (E Nr. )customerproductionthe enclosed list. the appliance. the and the number (FD) of E Nr. + Installation instructions en FD Product number Production number You can find the rating plate which contains this information in the frame of the open washing machine door and in the thick bordered box on the appliance rating plate at the back of the appliance. 2. Preparing and installing the transportation protection devices: F Please help by quoting the product number and production number to prevent unnecessary call outs. [. . . ] If a residual current operated circuit breaker is used, use only a type which features this symbol: 7 Only this symbol guarantees compliance with the currently valid regulations. Do not insert/pull out the plug with damp hands. Do not pull out the mains plug by tugging the power cord. Manufacturer (see Operating instructions) 1107/9000 301 578 After transportation, the transportation protection devices must be removed. [. . . ]