User manual SIEMENS WT66080GB

[. . . ] Instructions for use en EXTRAKLASSE 660 Contents Page Waste disposal New appliance packaging . 3 3 4 5 5 5 6 7 7 7 7 8 10 10 10 10 10 Environmentally friendly and economical drying Consumption rates . Summary of instructions Before drying . . Operating the appliance Switching from 10 A to 16 A . [. . . ] The drying time to be selected depends on the type of laundry, amount of laundry and the mois ture in the laundry. Set the programme selector to the desired warm or cold timed programme. The Programme time" indicator light illumi nates. 00" is displayed and the Change" indicator light flashes. Press the Change" button until the desired drying time is displayed in minutes (max. 90). Starting the programme 0. Press the Start" button The Start" indicator light illuminates Changing the programme 0. Possible at any time. Then press the Start" button again. Adding more washing or removing pre maturely0. Possible at any time. Put the laundry into the appliance or remove items of washing. Press the Start" button 11 Special programmes Smoothing Suitable for cotton or linen fabrics, easy care textiles made of cotton, blended fabrics or synthetic fibres. Creases in textiles from previous spin cycle are reduced. Textiles are not dried ready to wear and must be removed as soon as the programme ends (after approx. Turn the programme selector to the Smoothing" position. If required, select additional options (for additional option see Page 14). The Start" indicator light switches to a steady illumination. Woollen finish Suitable for wool textiles. Textiles are fluffier but not dried ready to wear and must be removed as soon as the programme ends and hung up. Selecting the programme The same as Smoothing, except set to Woollen finish". 12 End of programme The Anti crease/end" indicator light illuminates. A signal is emitted (only when function has been activated). If the laundry is not removed, the drum continues rotating at short intervals to prevent the laundry from creasing (35 minutes). The laundry should be removed now at the latest. Removing the laundry 0. If installation conditions are unfavourable, condensation may occasionally form around the filler neck. Laundry items which are being removed may come into contact with water droplets, but will be dry again within a few minutes. The drum is illuminated. Switching off the appliance 0. 1. The drum light goes out. 13 Additional options Low heat" button This button must be pressed for temperature sensitive textiles, e. g. [. . . ] Switch off the appliance, leave to cool down for 3 minutes. Switch on the appliance again and restart. - Any deviation to the programme sequence or a malfunction is displayed. Clean the fluff filter, check the pipe length, observe the installation conditions. [. . . ]