User manual SIEMENS WXD1260EU

[. . . ] Operating and Installation Instructions en Wash&Dry1260 Table of Contents Operating instructions Information concerning waste disposal . Protection of the environment / hints and tips . Before using your washer dryer for the first time . Preparing, sorting and loading the laundry . [. . . ] The time delay begins running immediately after the programme starts. This is displayed by the flashing first segment in the progress bar and the flashing apostrophe ' between the number and h. i The time delay is counted down by the hour. When the start time has elapsed, the programme starts automatically and the programme duration is displayed. i Changes to the start time or an immediate start are possible. To do this: - Briefly set the programme selector to another programme. - When the programme selector has been reset to the original programme, individual or all other settings may have to be reselected. i If the programme sequence is changed by rotating the programme selector or the programme is cancelled, the preselected start time is also cancelled. The programme duration of the newly selected programme appears in the display. The start time must be reselected (see also chapter Changing the programme, page 35 and Cancelling the programme, page 35). i The laundry can be topped up at any time during the start time. Close the washer dryer door. 32 Childproof lock You can secure your washer dryer to prevent selected functions from being inadvertently changed. If the childproof lock has been selected: - no changes can be made while the programme is running, - the symbol G flashes if a programme setting is inadvertently changed, - should the appliance be switched off and on while a programme is running, the programme will continue at the point at which it was interrupted, - the laundry can be topped up while the start time is running. Activating the childproof lock q Set the programme selector to the required programme and, if required, select other settings. q Load the laundry and close the loading door. i Release the M button. Example of easy care A 40 ºC programme: q Press the M button and hold down (for approx. 4 seconds) until the G symbol is displayed. q Release the M button, the childproof lock is acti vated, the symbol is permanently on. Deactivating the childproof lock The childproof lock must be deactivated before making programme changes or ending programmes with setting "---" (without final spin). q Press the M button and hold down (for approx. i If there is a power failure, the childproof lock remains on. 33 Signal The acoustic signal indicates: - that the additional functions (buttons) have been switched on or off, - individual programme statuses (e. g. start of programme, end of programme), operating errors and faults. Signal for switching buttons on and off q Press the M button and set the programme selector to cotton y 30 ºC. Hold down the M button until the signal is emitted. i When the additional functions are switched on, a long signal is emitted; when the additional function is switched off, the signal is short. [. . . ] Level the washer dryer with the assistance of the four adjustable feet and a spirit level: q Loosen the lock nut 1 using the wrench. q Adjust the height by rotating the foot 2. q Tighten the lock nut 1 against the housing. 61 Connecting the power Caution Connect the washer dryer only to an alternating current via a correctly installed earthed socket. The mains voltage must correspond to the voltage specification on the washer dryer (nameplate). [. . . ]