User manual SIEMENS WXLI4240EE

[. . . ] Operating instructions and installation en Atención al Usuario (España): 902 11 88 21 Washing machine Index IInstructions for use Advice on disposing of packaging and scrapping the appliance . Protecting the environment/ advice on reducing consumption . Preparing the laundry, classifying it and putting it into the machine . Adding the detergent and additives to the appropriate compartments . [. . . ] i If the programme is altered by turning the programme selector or if it is halted, the deferred start time programme is also halted. The display panel will show the duration of the newly selected programme, and the start time will need to be re-programmed (for more on this, see sections Altering a programme, page33 and Halting a programme, page33). i While a deferred start time is set, you can put articles into the machine at any time. Close the machine's door. 31 Child safety lock You can secure the machine against its programmed functions being accidentally altered. When the child safety lock is activated: - the wash programme that has been set cannot be altered, - the G symbol comes on if the selected programme is changed, - any wash programme that is running will disconnect and reconnect, and then continue from the point at which it was stopped, - whenever a deferred start time has been set, articles may be put into the machine at any time. Activating the child safety lock q Set the programme selector to the programme that you want to select, choose any additional settings that you might need. q Put the laundry in and close the door. i Release the Start button. Example for the programme Synthetics 40 ºC: q Press the Start button; keep it pressed down (approx. 4 seconds) until the G symbol comes on (appears on the panel). The child safety lock is now activated and the symbol will stay on. Deactivating the child safety lock To make any alterations to programmes, or to end a programme using the «---» option, the child safety lock has to be deactivated beforehand. q Press the Start button; keep it pressed down (approx. i The child safety lock will remain activated if there is a malfunction or if the electricity supply gets cut off. 32 During the wash Altering the selected wash programme If the wrong wash programme has been selected: q Temporarily deactivate the child safety lock if it is activated; for more on this see the explanation on page 32. q Set the programme selector to the position for the programme that is now required. If the pre-wash option is selected afterwards, the programme selector has to be set to the Stop position and the wash programme has to be re-selected. q Make any changes that you require; see page 28. i The altered programme begins running from the previous programme phase that was interrupted, but with the new settings. q If you wish to do so, reactivate the child safety lock (see page 32). Interrupting a programme that is running If you want to end a programme that is running and take the laundry out of the machine: q If the child safety lock is activated, it should be deactivated; see page32. q Set the programme selector to the b position, extra spin B or K. If necessary, select the spin speed ( do not select the option «---» (Stop after the last rinse!)). i If a programme is halted that is running with the wash water at a very high temperature, you should select the K function to allow the laundry to cool down. 33 q Press the Start button. q If you wish to do so, reactivate the child safety lock. q If necessary, deactivate the child safety lock. [. . . ] q After attaching the hose: Turn the tap full on and check that the joints are water-tight. min. 10 mm Draining the appliance Important When assembling and connecting the appliance to the drainage network, make sure that the hose does not get bent or trapped. The drainage outlet should be 100 cm from the floor at most. If drainage is made via a U-bend: q Secure the connection using a clamp with a 24-40 mm diameter (may be obtained from a specialist shop). If drainage is made via a sink: Important Make sure that the plug is not blocking the sink. [. . . ]