User manual SIEMENS WXSP100AOE

[. . . ] Instruction Manual and Installation Instructions en washing machine Table of Contents Operating Instructions Information concerning waste disposal . Protection of the environment / Hints and tips . Before using your washing machine for the first time . Preparing, sorting and loading the washing . [. . . ] i When the additional functions are switched on, a long signal is emitted; when the additional function is switched off, the signal is short. The volume of the signal cannot be changed. Signal for switching buttons on and off Signal for programme status The signal can be switched on and off and the volume set before the start or after the end of the programme. q Press the v Intensive Wash button and hold down until the signal is emitted and the volume of the signal changes. q Release the button when the required volume is reached. The selected setting is stored. 31 During washing Changing the programme If you have accidentally selected the wrong programme: q If the childproof lock is active, temporarily deactivate; see page 30. q Turn the programme selector to a newly selected programme. If prewash is selected subsequently, set the programme selector to m Off and reselect the programme. q If required, change the other settings; see from page 26. i The newly selected programme starts at the programme section at which the previous programme was cancelled, however with the new settings. q If required, re activate the childproof lock (see page 30). 32 Cancelling the programme If you would like to terminate a programme and remove the washing: q If the childproof lock is active, deactivate; see page 30. q Turn the programme selector to b Drain, B Spin or K Rinse. If required, select the desired spin speed (but not setting --- (without final spin)). i If a programme is interrupted at a high temperature, K Rinse should be selected to cool down the washing. q If required, switch on the childproof lock again. q If required, deactivate the childproof lock. i If a programme was interrupted at a high temperature, the washing machine door may remain locked until the appliance has cooled down. 33 After washing i Display panel: - all symbols on the programme status display have gone out, the full bar is displayed, - the programme duration is on -0-, - if the childproof lock is selected, the G symbol illuminates, - if detergent was overdosed, the : symbol illuminates. q If required, deactivate the childproof lock. q Turn the programme selector to m Off. or Setting --(without final spin) selected i Display panel: - the B symbol and the full bar are indicated on the programme status display, - the programme duration is on ---. - if the childproof lock is selected, the G symbol illuminates, - if detergent was overdosed, the : symbol illuminates. q If required, deactivate the childproof lock. 34 q Select an additional programme b Drain or B Spin. q If required, activating childproof lock. At the end of the additional programme: q If required, activating childproof lock. [. . . ] - The earthing system has been installed correctly. The mains cable may be changed (if required) by an electrician only. Replacement mains cable available from customer service. Do not use multiple plugs/sockets or extension cables. [. . . ]