User manual SILENT KNIGHT REGENCY 4720C-COMMERCIAL

[. . . ] Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . System Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Monitoring Capabilities . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Intrusion. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To do this, press the STAT button and the LCD will display the zone number and location of the open sensor (for example, 3 BACK DOOR). Close the door involved and the unit will automatically indicate a ready status (READY light is on). If the display reads TROUBLE, press the STAT button and the display will list the trouble conditions (see page 24). Viewing Alarms and Alarm Memory When an alarm occurs, the touchpad displays ALARM on the first line of the LCD. Press MEM to view the location of the alarm. Viewing Trouble and Supervisory Conditions When a system trouble or sprinkler supervisory condition occurs, the touchpad will beep and display TROUBLE or SUPERVISORY on the first line of the LCD. Press STAT to view the location of the trouble or supervisory. Viewing Alarm Memory The alarm memory function records alarm information. Events remain in memory for a single arming period. Press MEM to display the zone Page 10 User's Manual Section 3. Using Your Model 4720 Security System number and location of any alarms that have occurred since the last time the system was armed. The next time you arm the system, memory from the previous arming period will automatically be erased. Silencing Trouble Sounds To silence a trouble condition alert tone, press MUTE MUTE . The LCD will display SILENCED instead of TROUBLE. If a new condition occurs, the TROUBLE display and alert tone will be reactivated. Bypassing Zones You may need to bypass certain zones at certain times. Remember that while a zone is bypassed, there is no protection on that zone. Do not give the code that allows for bypassing to casual users of the system such as cleaning or delivery persons. The BYPS button is used to disable individual intrusion zones. You cannot bypass 24-hour fire and panic zones. Bypassing a Zone When the system is disarmed: 1. Enter the number of the zone you wish to bypass. Enter your access code, if required. If the LCD reads RESTRICTED, and you hear a warning tone, you have attempted to bypass a fire or panic zone that cannot be bypassed. To find out what zones are bypassed, simply press BYPS . Reinstating a Bypassed Zone When the system is disarmed: 1. [. . . ] The beeper will sound (warning sound is optional) until the delay time is up and the LCD will display the countdown to exit time. Special sensors installed to protect furnaces, freezers, and so on have triggered an alarm. One or more of the zones have been bypassed, or turned off. This message will not be displayed if the system is armed. [. . . ]