User manual SILVERCREST KH 2306 MICRO STEREO SYSTEM

[. . . ] Read these operating instructions carefully before using the device for the first time and preserve this booklet for later reference. Pass this booklet on to whoever might acquire the device at a future date. This device is intended for the reception of FM/AM radio stations, the playback of Audio and MP3-CDs, as well as the playback of audio signals of external devices. This device is intended for use only in domestic settings. [. . . ] Carefully close the battery compartment lid until it clicks into place. Do not permit small children to play with the plastic packaging. If you do not intend to use the device for an extended period, remove the batteries. Always change all batteries at the same time and always use batteries of the same type. Should the batteries leak, wear protective gloves and clean the battery compartment with a dry cloth. In radio operation, turn the whole appliance to a position where the best radio reception is obtained. For receiving FM transmissions, the Micro System is equipped with a small wire aerial in the back of the unit. In order to ensure excellent reception with your Micro System, carefully pull out the wire aerial completely. Do not plug the Micro System into the mains power until all connections have been made. Keep the clamp of the respective speaker jack depressed while inserting the wire. Connect the speaker cable of the Micro System's left loudspeaker by plugging it into the double jack marked "L". You can connect stereo headphones to the Micro System with a 3. The jacks for the headset PHONES are located at the front of the Micro System. When headphones are connected, the loudspeakers are switched off and you will only hear sound via the headphones. Listening to music with headset for long periods and at high volume levels can lead to hearing damage!When all of the required connections have been made, insert the plug on the power cable into a wall power socket. The device is now in standby mode and the green stand-by LED is illuminated. while in standby mode , the time is displayed. If the time has not been set yet, the display will show: 0:00. In order to set the time, please read the following instructions. Connect the stereo plug of the audio device with the jack AUX IN at the front of the Micro System. While in standby mode, depress the button CLOCK SET for more than two seconds. [. . . ] In order to play back one of the previous CD's songs, keep pressing the button BACK ( on the remote control) until the number of the desired title appears. When using a MP3-CD the button FOLDER-/-10 or FOLDER+/+10 on the remote control (on the device only FOLD+/+10) may be used to skip back or move a head 10 titles. If a MP3-CD contains folders, the folder may be searched forward or in reverse order while pressing and holding the button FOLDER-/-10 or FOLDER+/+10 on the remote control (on the device only FOLD+/+10). The display may show F01 for the first folder. [. . . ]