User manual SILVERCREST KH 245 WIND-UP RADIO

[. . . ] ⷠUse only power adapters with an output rating of 4. When connecting a power adapter, ensure that the polarity of the barrel plug concurs with the polarity details for socket DC 4. Do not operate the device if the mains adapter, the adapter's power cable or the device itself is damaged. Should you do so, device safety can no longer be assured and the warranty will become void. [. . . ] Children should be supervised to ensure that they do not play with the device. Do not leave packaging material lying unattended. plastic foils and bags and pieces of styropor etc. Are not toys, they can be dangerous for small children. Damage to the device Do not place the device on sloping surfaces, it could fall down and be damaged. If you do not intend to use the device for an extended period, remove the batteries. Always change all batteries at the same time and always use batteries of the same type. Q w e r t y u i o a s d Loudspeaker ILLUMINATION TUNE CHARGE SIREN Telescope antenna LED bulb TUNING FM/AM OFF/VOLUME: Sender scale DYNAMO/BATTERY - switches the illumination on and off - indicator for reception strength - lights up when charging the batteries - switches the siren on and off - tuning in of radio stations - frequency range switch - On/Off switch, volume regulator - for switching between power sources f Dynamo lever - for manual electricity generation gBattery compartment cover h Lock-device for the battery compartment cover j Rubber covers - for the protection of connection sockets k DC 4. Taking the device into use For this, fold out the dynamo grip on the rear of the device and turn the dynamo lever f for several minutes at approx. 120 revolutions per minute in any direction. Battery operation The device can also be operated with batteries (not supplied). > Pay heed to the correct poling of the batteries, otherwise the device will not function and could even be damaged. > Replace the battery compartment cover g and screw it down firmly with the lock-device h. Connecting the mains adapter You can operate the device with a power adapter (not supplied) that concurs with the specifications given in the section "Technical Data". > Using a fingernail , open the rubber cover j. > Insert the barrel plug of the power adapter into the socket for the power supply (DC 4. > Then insert the plug of the power adapter into a mains power socket whose voltage matches the information given on the power adapter type plate. The DYNAMO/BATTERY switch d, with which you can select different power sources, is located on the rear of the device. > Place this switch in the position DYNAMO to power the device from the built-in Ni-MH batteries. > Place this switch in the position BATTERY to power the device from the batteries in the battery compartment. > Power provision from a mains power adapter functions in both switch positions. Should the device functions diminish whilst it is being powerered from the built-in Ni-MH batteries, it means they are drained. [. . . ] Should you, in spite of our high quality standards, have grounds for complaint please contact our Service Hotline. In the event that processing of your complaint is not possible by telephone you will receive · A processing number (RMA number) as well as · An address to which you can send your device for repair under warranty. in the case of a mail-in shipment please enclose a copy of the purchase receipt (sales slip). The device must be securely packed and the RMA number clearly visible. [. . . ]