User manual SILVERCREST KH 2188

[. . . ] In some countries, different national regulations may apply in regard to the assigned radio frequency ranges. Note that information received from transmissions outside the assigned radio frequency ranges may not be exploited, passed on to third parties or otherwise improperly misused. To avoid potentially fatal electric shocks: · Connect the device only to correctly installed and earthed mains sockets. Ensure that the rating of the local power supply tallies completely with the details given on the rating plate of the device. · Make sure that the power cable never becomes wet or damp during operation. [. . . ] If possible place an anti-slip material under the feet of the device. Risk of explosion! · Do not throw batteries into a fire. Do not recharge the batteries. To avoid the risks of fire or injury: · Do not place candles or other open fire sources on the device. · Do not use the device in the vicinity of hot surfaces. -3- Operating Elements q Power cable w Battery compartment KH 2187: on the underside, KH 2188: at the rear Inserting the batteries Power-cut protection Through the insertion of a 9 V block battery (Type 6LR61) you will avoid that, in the event of a power failure, the functioning of the device is interrupted and, as a result, saved settings, such as time and alarm time, are lost. The battery ensures that the radio alarm continues to function with an emergency operation, also during a power failure. On restoration of the power supply, the correct time will appear automatically on the display f. e r t y u i o a s d f g h j k l Wire aerial Speaker Button SNOOZE Button HOUR Button MIN (KH 2188: MINUTE) Button SLEEP Button AL. OFF Button TIME Frequency scale Display Volume regulator Slide switch MODE AUTO (AL)/OFF/ON Switch for alarm mode ALARM/RADIO Waveband selector BAND FM/AM TUNING regulator Note: The alarm, radio and display do not function with battery-power. · Open the battery compartment w and insert a 9 V block battery (Type 6LR61). Handling batteries Commissioning Setup · Unpack the radio alarm and all ancillaries. · Remove all transport restraints and adhesive tape/films. Leaking batteries can cause damage to the radio alarm. · If you do not intend to use the device for an extended period, remove the battery. · Should the batteries leak, clean the battery compartment with a dry cloth whilst wearing protective gloves. Attention! Do not permit small children to play with the plastic packaging. · Position the radio alarm on a level and horizontal surface. Note: Rechargable batteries cannot be charged via the battery connection. In the event of an extended power cut (several hours), the clock and alarm times must be checked and possibly re-adjusted. Assembly Before operating the device, make sure that it is in a faultless condition. · Insert the plug into a power socket. Select a power socket that is at all times easily accessible, so that the plug can be quickly withdrawn in the event of a malfunction. -4- Setting the clock When you take the device into use for the first time after inserting a new battery: Whilst pressing and holding the button TIME s: · Repeatedly press, or press and hold, the button HOUR y to set the hours. · Release the HOUR y button as soon as the required hour indicator is shown in the display f. · Repeatedly press, or press and hold, the button MIN resp. MINUTE u button as soon as the required minute indicator is shown in the display f. The programmed time setting is automatically accepted as soon as the button TIME s is released. Setting the alarm time When the correct time has been programmed in as described above, proceed as follows: Whilst holding the button AL. ON o pressed down: · Repeatedly press, or press and hold, the button HOUR y to set the hours. · Release the HOUR y button as soon as the required hour indicator is shown in the display f. · Repeatedly press, or press and hold, the button MIN resp. MINUTE u button as soon as the required minute indicator is shown in the display f. [. . . ] · Slide the switch for the alarm mode j into the position RADIO. You can extend the time to switch off by. . . · pressing and holding the button SLEEP i and, at the same time, raise the switch off time to 1 hour and 59 minutes with the button HOUR y. You can reduce the time to switch off by . . . [. . . ]