User manual SILVERCREST KH 2302

[. . . ] Read the operating instructions carefully before using the appliance for the first time and preserve this booklet for later reference. This device is intended for the reception of FM/AM radio stations, as well as for the playback of Audio CDs and MP3 files from CDs, USB data carriers and SD/MMC memory cards. This device is intended for use only in domestic settings. It is not suitable for use in commercial or industrial applications. [. . . ] Carefully roll the wire antenna fully out, so that the micro-system can provide good reception. Listening to music with headphones for long periods and at high volume levels can lead to hearing damage!When all of the required connections have been made, insert the plug on the power cable into a wall power socket. Should FM radio reception via the supplied wire antenna be fully inadequate, you can connect a house antenna to the micro system. ⷠInsert the antenna plug of the house antenna into the connection socket 75 OHM JACK on the micro system. To switch the device completely off, press the button POWER once again. The programming for the time is NOT retained if the device is separated from the power network. You can adapt the sound quality to the respective type of music by means of the sound setting. You can choose between the following settings: POP - JAZZ - FLAT - CLASSIC - ROCK · Press the button EQ repeatedly until the required sound adjustment is indicated in the display. If you adjust the sound setting while playing, the sound will change immediately. In the setting FLAT the sound is played back unchanged. You can select from the following modes: CD (CD playback) USB (Playback of MP3 files from a USB memory stick) CARD (Playback of MP3 files from a memory card) AUX (Playback of an audio device connected to the connection You can only adjust the clock in standby mode. To raise the sound volume, press the button VOLUME+ on the remote control or on the front of the device. ⷠTo lower the sound volume, press the button VOLUME- on the remote control or on the front of the device. To switch the sound back on, press the MUTE once again or press one of the VOLUME buttons. The programming for the time is NOT retained if the device is separated from the power network or switched off with the power switch. You can program your micro-system to wake you up. For this purpose you can set the desired waking time, the sound source and the volume. The micro-system will then switch itself on and off according to the set time. You can choose to be woken by the radio or by sounds from a CD, memory card or a USB memory stick. To save the setting, press the button TIMER once If you wish to be woken by sounds from a CD, memory card or a USB memory stick, you must insert the appropriate medium beforehand. if you wish to be woken by the radio , tune in to a radio station as described under "Radio mode". [. . . ] Dispose of the device through an approved disposal centre or at your community waste facility. observe the currently applicable regulations. In case of doubt, please contact your waste disposal centre. Due to the vast number of available storage mediums there can be no guarantee of compatibility with all current and future storage mediums. [. . . ]