User manual SILVERCREST KH9

[. . . ] Arrange for defective power plugs and/or cables to be replaced at once by qualified technicians or our Customer Service Department. This heating appliance has been filled with a specific volume of a special oil. Should the appliance become damaged or leak oil then it may no longer be taken into use. Should you do so, the safety concept of the device may be compromised and the warranty becomes void. [. . . ] check to ensure that the recesses on the roller railers 9 face outwards. The screw ends projecting from the appliance must reach into the recesses. Screw one wing nut 0 onto each of the threaded ends of the mounting bracket 8 until it is hand tight. Proceed in the same manner with the other side. Oil Radiator 2 Roller rails 2 Mounting bracket 4 Wing nuts Operating instructions Unwind all of the power cable from the power cable retainer 7. If you wish to switch the appliance off, first place the warm air switch 4 at the position OFF. Next, turn the heat level switch 2 to "0" and then the thermostat 3 to MIN. Remove the plug from the wall power socket. Ensure that the thermostat 3 and the heat level switch 2 are standing at MIN resp. Insert the power plug into a wall power socket. You can programme this oil radiator so that, if the room temperature falls near to 0°C, it switches itself on and begins to radiate heat automatically: 1. Insert the power plug into a wall socket. The oil radiator will now switch itself on if the temperature falls near to 0°C. When the temperature rises above 0°C, the oil radiator switches itself off automatically. The oil radiator will switch on and off periodically to maintain the room temperature above 0°C. With the heat level switch 2 you can regulate how quickly the appliance warms up. If you wish to heat it up particularly quickly, select heat level "III", if a slow warming up is preferred, select heat level "I". Using the thermostat 3 you can set it to the desired temperature. When the desired room temperature has been reached, slowly turn the thermostat 3 back until a quiet "click" is heard and the control lamp "Power" 1 extinguishes. The momentary room temperature will now be retained. It could be that every now and then the control lamp "Power" 1 switches itself on and then back off. This means that the programmed room temperature had fallen below this level for a short period and the appliance had warmed itself back up. [. . . ] This product is for private use only and is not intended for commercial use. In the event of misuse and improper handling, use of force and manipulations not carried out by our authorised service centre, the warranty will become void. Your statutory rights are not restricted in any way by this warranty. Do not dispose of the apliance in your normal domestic waste. [. . . ]