User manual SILVERCREST SAB 4.8 A1

[. . . ] 30 min Charging time for an empty battery 12 - 16 hours. -1- Assembling the floor sweeper The numbers before the operating steps refer to the illustrations on the fold-out page. Assemble the broomstick by inserting the 3 elements into each other and turn to secure. Attach the wall bracket with the enclosed screws. Caution: · Only use the enclosed charger (9V 200 mA). Other charging devices could irreparably damage the appliance! [. . . ] · Guide the rechargeable battery floor sweeper over the floor. · You can leave the floor sweeperstick locked in vertical position during work interruptions. Note: With some types of carpet the rechargeable battery floor sweeper could rattle or bounce. In this case work slowly and in the opposite direction. -2- Cleaning How to clean the dirt container: To maintain the efficiency of the rechargeable battery floor sweeper, empty the dirt container after every use. Press the unlocking button of the dirt container to detach it from the device. With a slight upward movement, pull the dirt container horizontally from the device. · Empty the dirt container and re-insert. Caution: · Ensure that the device is not inadvertently switched on with the dirt container removed or while cleaning the brush. · Do not clean the device during the charging process. Risk of Injury! Storage Use the supplied wall bracket for practical and space-saving storage or when charging the device. How to clean the brush: If the brush roller cannot be turned any longer because of accumulated coarse dirt or threads, proceed as follows: · Turn over the rechargeable battery floor sweeper and hold it so that the flat side with the brush roller faces you. Remove the small cover on the right-hand side. · Loosen the drive belt by pushing it to the right. µ Lift the brush roller on the right-hand side and remove the guide bushing with the washer . ¸ Now pull the brush roller from the device to the right-hand side. · Remove the dirt (on both sides of the bristle) and clean the brush. After cleaning, proceed as follows to re-install the brush roller: · Insert the drive belt in the compartment and place it around the motor drive pulley. · Place the washer on the guide bushing and insert the brush roller into the left guide channel. · Pull the drive belt over the guide bushing and re-insert the brush roller into the right channel. · Now pull the drive belt over the drive cog of the brush roller. · Fit the brush cover by first introducing the lower lugs in the recesses and press the cover in at the top. Caution: · Do not expose the rechargeable battery floor sweeper to extreme temperatures or moisture. · Do not therefore store it near ovens, heating elements, burners or in the bathroom. · Never leave the device without it having been switched off - the rechargeable battery could be damaged through depletion. -3- Disposal Do not dispose of the appliance in your normal domestic waste. [. . . ] This applies also to replaced and repaired parts. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. DES UK LTD Tel. : 0871 5000 700 (£ 0. 10 / minute) e-mail: support. uk@kompernass. com Kompernass Service Ireland Tel: 1850 930 412 (0, 082 EUR/Min. ) Standard call rates apply. [. . . ]