User manual SILVERCREST SAS 7.4 LI A1

[. . . ] 2012 12:03 Uhr Seite 17 Content Intended Usage Important safety instructions Items supplied Appliance description Technical data Information about the batteries Installation of the wall holder Charging Operation Cleaning Disposal Warranty and Service Importer Page 18 18 19 19 20 20 20 21 21 22 22 23 23 Read the operating instructions carefully before using the device for the first time and preserve this booklet for later reference. Pass this manual on to whoever might acquire the device at a future date. 2012 12:03 Uhr Seite 18 Li-Ion Rechargeable Handheld Vacuum Cleaner Congratulations on the purchase of your new appliance. You have clearly decided in favour of a quality product. [. . . ] It would be a potentially fatal risk to bore into a current carrying electric cable!Place the barrel plug 5 of the power adapter 4 into the wall holder 3 as shown in the diagramme. Before using the cableless hand vacuum cleaner for the first time, the batteries must be charged for at least 24 hours. The batteries reach their full capacity after a charging period of 24 hours. For care of the batteries we recommend the following: after the batteries are charged, remove the power adapter 4 from the mains power socket. Reconnect the power adapter 4 again with the mains power socket when the suction power of the appliance is noticeably weaker. Select a suitable installation location for the wall holder 3: It should present no problem with taking the hand vacuum cleaner out of it and a mains power socket for the power adapter 4 must be accessible. Bore two holes with a spacing of approx. Use the wall holder 3 to mark the boreholes: this will ensure the spacing is correct. The boreholes must be suitable for 5 mm wallplugs. Insert the wallplugs into the boreholes and, using the screws, firmly screw the wall holder 3 to the wall. You can place the nozzles on the lateral accessories holder. Connect the power adapter 4 to a mains power socket. 2012 12:03 Uhr Seite 21 Charging Note: Check to ensure that the on/off switch 6 has been slid back (to the position "0") before starting the charging process. €¢ Place the hand vacuum cleaner from above into the wall holder 3, so that the barrel plug 5 slips into the socket on the hand vacuum cleaner. The charge indicator lamp 7 glows red and the charging process begins. The suction opening must always be open and unblocked. Blockages lead to overheating and damage to the motor. Tips: • Make certain that the dust filter 0 is always inserted before using the appliance. €¢ As the maximum, suck up only as much liquid as will fill the dirt container q to the MAX mark. Take the hand vacuum cleaner from the wall holder 3 or, if you do not use the wall holder 3, remove the barrel plug 5 from the socket. If required, place the appropriate nozzle into the suction opening: • the crevice nozzle 2, to clean narrow and difficult to reach locations. [. . . ] Pull the dust filter bag 9 with its mounting out of the dust filter 0. Rinse the dust filter bag 9 in cold water and then wait until it is completely dry again before you place it back into the dust filter 0. Place the dust filter 0 back into the dirt container q. Ensure that the dust filter 0 is seated squarely and that the rubber lip seals the dirt container q. [. . . ]