User manual SILVERCREST SBTF 10 A1

[. . . ] 3 General safety instructions · Do not attempt to open or repair the appliance. Should you do so, appliance safety can no longer be assured and the warranty becomes void. · Have the defective device repaired by customer service or an authorised specialist only. No liability will be accepted for damage caused by misuse, improper handling, use of force or unauthorized modification. [. . . ] Further information about Bluetooth® radio technology is to be found in the operating instructions for your mobile telephone. Before you can use the hands-free appliance, you must connect it with a compatible mobile telephone (pairing). · Check to make sure the mobile telephone is switched on. · Programme the mobile telephone so that it searches for Bluetooth® appliances. A detailed description of how to do this is to be found in the operating instructions for your mobile telephone. · Ensure that the hands-free appliance is correctly set up and switched off. 9 · To switch the device off, press and hold the multi-function button 4 for about 3 seconds. A long, low signal tone will be heard and the LED status display 6 extinguishes. · Position the hands-free appliance and the mobile telephone so that they are not more than 1 metre away from each other. · Press and hold down the multi-function button 4 for 6 seconds until, after 3 seconds a short, high signal tone and after a further 3 seconds a succession of low and high signal tones are heard. The LED status display 6 lights up constantly and the hands-free equipment is now in the coupling mode. · Select the hands-free provision , , Car Kit" from the list of available appliances for the mobile telephone. · Enter in the pre-programmed passcode "9999" and then confirm it, which couples the appliances with each other. You will hear a long high signal tone and the LED status indicator 6 blinks every 3 seconds. · You can now use the hands-free appliance. Note: If the coupling is not completed within 2 minutes, the hands-free appliance switches itself off. The LED status display 6 extinguishes and you will hear a long and deep signal tone. With some mobile telephones it is possible that coupling does not automatically take place. In this case coupling must be carried out additionally on the mobile telephone. The LED status display 6 blinks twice every 3 seconds until this has been carried out. Further information can be found in your mobile telephone's operating instructions. 10 Coupling the hands-free appliance with several mobile telephones You can couple the hands-free appliance with up to eight mobile telephones. However, it can only be connected with one mobiletelephone. If a further mobile telephone is coupled with the hands-free appliance, the coupling information of the first coupled mobile telephone is erased. When the hands-free appliance is switched on, within a few seconds it attempts to make a connection to the last used mobile phone. [. . . ] Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. DES UK LTD Tel. : 0871 5000 700 (£ 0. 10 / minute) e-mail: support. uk@kompernass. com Kompernass Service Ireland Tel. : 1850 930 412 (0, 082 EUR/Min. ) Standard call rates apply. Mobile operators may vary. e-mail: support. ie@kompernass. com 16 Importer KOMPERNASS GMBH BURGSTRASSE 21 44867 BOCHUM, GERMANY www. kompernass. com 17 Information regarding the conformity declaration We, Kompernaß GmbH, declare that the product SBTF 10 A1 Bluetooth® HandsFree Kit conforms to the basic requirements and other relevant provisions of the vehicle directive 2004/104/EC and the R&TTE directive 99/5/EC of the European Union council. [. . . ]