User manual SILVERCREST SDBK 2200 A1

[. . . ] Should care instructions not be given or known, start with the lowest temperature setting. NEVER permit children to use the steam iron. The station must be stable when you place the steam iron onto it. If you want to put the steam iron down, simply stand it on the cable base or place it in the station. [. . . ] The steam iron now allows itself to be lifted off. In a cooled condition, place the steam iron horizontally on its sole e. Slide off the cover of the filler opening for the water tank 2. Using the measuring beaker, fill the water tank with water to the "Max" marking, but no further. Slide the cover of the filler opening for the water tank 2 back to close it. Should the mains water at your locality be rated as hard, it is recommended that you mix mains water with some distilled water. Otherwise, the jets for the steam blast function could calcify (become blocked) prematurely. To extend the optimal steam blast function, mix mains water with distilled water according to the table. As the steam iron cannot be heated up without the cable base 8, you can only work for a short period without the cable base 8. Reconnect the steam iron with the cable base 8 as soon as the steam blast or the ironing quality diminishes. Water hardness very soft / soft medium hard very hard When the set temperature has been reached, the temperature control lamp 6 goes out. This function is suitable for very dry and very crumpled garments. The water hardness level can be queried at your local water works. Dry ironing without steam is possible at all temperatures, steam ironing is first possible from the adjustment range on the temperature regulator 7. Should the clothing care instructions forbid ironing, (Symbol ), the clothing item may not be ironed. If you do so, the clothing item could be permanently damaged. Check the care instructions on the labels in the garment to see if it is suitable for being ironed, and at which temperature setting. The temperature regulator 7 must be turned into at least the adjustment range . The steam blast is especially suitable for smoothing difficult to reach parts of a garment. Never leave the steam iron unattended when it is hot or switched on. Place the steam iron only on the cable base 8 or insert it onto the station q. With conventional steam irons it can happen that water drips from the iron sole e at low temperatures. [. . . ] The steam iron is not plugged in or is not switched on. Insert the plug into a wall power socket and adjust the temperature regulator 7 to the desired ironing temperature. The warranty period will not be extended by repairs made under warranty. this applies also to replaced and repaired parts. [. . . ]