User manual SILVERCREST SDS 3000 A1 TELESCOPIC CAMERA TRIPOD

[. . . ] Children should be supervised to ensure that they do not play with the appliance. If you do not, it may fall over and the tripod as well as the attached device may be damaged. Ensure that the device is firmly screwed onto the quick release plate. Otherwise, it may fall off and become damaged! [. . . ] 2) Turn the locking ring w firmly in a clockwise direction so that it can no longer move. 3) Loosen the locking levers e+r to unlock the legs of the tripod and pull them out to the required lengths. 4) Align the tripod by shifting the legs as required. For this use the levelling spirit level 6. NOTICE The air bubble must be located in the middle of the circular marking. 5) When you have found the right position, relock the tripod legs with the locking levers e+r. 6) Now align - if you want to have the tripod plate 3 lined up exactly horizontally - the tripod plate 3. For this, turn on the grip 0 and move it up or, respectively, down. NOTICE The air bubble of the adjustment spirit level 4 must be located between the two markings. NOTICE This tripod is equipped with a quick release plate 2. When a device is screwed onto the quick release plate 2 you can, by sliding the locking device 8 on the side of the tripod plate 3, loosen the device together with the quick release plate 2 from the tripod plate 3. Thus, you do not always have to unscrew the device from the thread 1. 1) Remove the quick release plate 2 from the tripod. For this, slide the locking device 8 to the side so that you can lift the quick release plate 2. 2) Screw the required device onto the quick release plate 2. To do this, turn the screw - with the help of the handle on the underside of the quick release plate 2 - until the device is firmly seated. 3) To replace the quick release plate 2 complete with the device back on the tripod plate 3, slide the locking device 8 to the side and reposition the quick release plate 2. Then secure the locking device 8, such that the quick release plate 2 is firmly seated. When you have set the tripod up and the device is mounted on it, you can then adjust it as follows: Loosen the locking screw "High" 7 to a point where the crank q can be turned easily. When the desired height has been reached, firmly retighten the locking screw "High" 7. [. . . ] If you need to transport the tripod over long distances, then slide it together and place it into the supplied transport bag. Store the tripod at a clean and dry location. Clean the tripod with a lightly moistened cloth. Dispose of the appliance through an approved disposal centre or at your community waste facility. [. . . ]