User manual SILVERCREST SFB 120 B2

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. Fitting the attachment for the centre console . 12 16:16 Information for these operating instructions These operating instructions are a component of the Foot Bubble Bath SFB 120 B2 (henceforth designated as the appliance) and they provide you with important information about the intended use, safety and connection as well as operation of the appliance. GB The operating instructions must be constantly kept available close to the appliance. [. . . ] 3) Clean all parts of the appliance as described in the section "Cleaning". NOTICE ► Check the contents to ensure everything is present and for signs of visible damage. –º If the delivery is not complete, or is damaged due to defective packaging or through transportation, contact the Service Hotline (see chapter Service). GB Disposal of the packaging The packaging protects the appliance from transport damage. The packaging materials are selected from the point of view of their environmental friendliness and disposal technology and are therefore recyclable. The recirculation of packaging into the material circuit saves on raw material and reduces the amount of waste generated. Dispose of packaging material that is no longer needed as per the regionally established regulations. NOTICE ► If possible, preserve the appliance's original packaging during the warranty period so that, in the event of a warranty claim, you can package the appliance appropriately for its return. 12 16:16 Technical data Mains voltage Rated power Protection class 220 - 240 V ~, 50 Hz 120 W II 20 Minutes GB CO Time CO Time The C. After the appliance has run for this period it must be switched off for about 15 minutes, until the motor has cooled itself down. Description of appliance / attachments Appliance and accessories: 1 Function switch 2 Spray protector 3 Massage rollers 4 Air jets 5 Plug holder 6 Insertion slot for attachments 7 Infrared light 8 Water drainage 9 Attachment holder 0 Callous remover q Roller attachment w Brush attachment Positions of the function switch 1: Ạ Position 0 ạ Position Infrared light and Massage Ả Position Heat and Bubbles ả Position Infrared, Massage, Heat and Bubbles 30 IB_73829_SFB120B2_LB1. 12 16:16 Functions of the Foot Bubble Bath This Foot Bubble Bath has 4 functions available which can be used in various combinations : – 1. Bubbles: Air emerging from the air-jets 4 provides for the formation of air bubbles, which gently and pleasantly massage the feet. The foot pad heats itself and thus provides for a constant water temperature. The foot accessories with massage nubs create through vibration a pleasant massage effect. Infrared light: The infrared light 7 warms the feet, thus promoting blood circulation. Operation Setup ♦ ♦ Place the Foot Bubble Bath on the floor in front of a chair. place the function switch 1 at 0 (OFF). Fitting the attachment for the centre console ♦ Select an attachment 0/q/w for the centre console: – Brush attachment w: to stimulate the reflex zones in the sole of the foot and for massage. €“ Roller attachment q: is used to massage and promotes blood circulation. [. . . ] The appliance could be irreparably damaged. After the foot bath ♦ ♦ ♦ ♦ Switch the appliance off at the function switch 1 and remove the plug from the mains power socket. Carefully empty the water out through the water drain 8. After the foot bath apply skin care oil to your feet. [. . . ]