User manual SILVERCREST SFS 150 A1

[. . . ] Also, do not use the appliance if you have wet hands. · Ensure that the power plug is at all times freely accessible, so that in a case of emergency it can be quickly removed from the power source. · Ensure that when the appliance is in use the power cable cannot become jammed or damaged in any way. Place it such that no one can trip or stumble over it. [. . . ] Hold the Seal/Cut button y pressed down until the control lamp down i goes out. Note: Then close the appliance cover u. To achieve the best results, press the Seal/Cut button y down continuously, applying an even pressure and using both hands. -4- Warning: If the control lamp i does not go out after 10 seconds at the latest, the appliance is defective!Immediately remove the plug from the wall socket. Do not attempt to repair the appliance yourself. In this case, contact Customer Services. Place the open end of the bag around the extraction supports w. Thereby, the bag must project to the markings in the appliance. Open the appliance cover u again and remove the film. This is sealed at one end and, at the same time, separated from the roll of tube film. Seal the remaining open sides, except for one, in the same manner. You must leave at least 6 cm of the bag free, measured up to the edge that is to be sealed. Warning: Fill the bags in such a way that, under no circumstances, food remnants or fluids can run out of the bag when sealing it and permeate into the appliance. Note: The bag opening must sit smoothly on the extraction supports w, the sealing wire r and the cutting wire e. Otherwise, the vacuuming, sealing and cutting will not function properly. If you do not want to extract the air from the bag, you should now seal the last open side. Vacuuming films When sealing, you can at the same time extract the air from the bag (vacuuming): Close the appliance cover u and firmly press it down on both sides. Be sure not to press on the Seal/Cut button y. Air is now sucked from the bag. Warning: Do NOT vacuum bags in which there are liquids. They will permeate into the appliance and damage it. -5- As soon as the air has been sucked from the bag, press and hold the Seal/Cut button y with both hands, as already described, and seal the bag. Open the appliance cover u. Carefully pull the collector receptacle q out of the appliance using the lateral grips. Clean it in a lukewarm washing-up solution and the allow then collector receptacle q to dry well. Replace the collector receptacle q and fold the extraction supports w down. Cleaning the appliance Storing the appliance Do not wrap the power cable around the appliance, use the guides provided on the bottom of the appliance. Store the appliance where it will be dry and free from dust and particles, so that nothing can lodge in the suction device. Clean the appliance only with a dry or lightly moistened cloth. Do not use abrasives or detergents, these could damage the plastic surfaces. Do not remove stubborn glue remnants from the sealing wire r with hard or sharp objects, at the very most carefully use a fingernail. Otherwise, the sealing wire r, the cutting wire e or the insulation underneath could be damaged. Maintenance Warning: NEVER open the housing!There is potentially fatal high voltage in the appliance. Arrange for the appliance to be repaired by specialists only. No form of maintenance, either on or in the appliance, is intended for execution by the user. [. . . ] This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. Your statutory rights are not restricted in any way by this warranty. The warranty period will not be extended by repairs made under warranty. [. . . ]