User manual SILVERCREST SKM 550 A1

[. . . ] KITCHEN TOOLS 6 Food Processor SKM 550 A1 CY Food Processor Operating instructions KOMPERNASS GMBH BURGSTRASSE 21 · D-44867 BOCHUM www. kompernass. com ID-Nr. : SKM 550 A1-01/10-V2 q w w q q w w q q d w e r f s a u o i l t g h j k y CONTENT Safety Notices Intended Use Technical data Items supplied Appliance description Taking into use Operating positions Working with kneading hooks, beaters and whisks Working with the food processor Working with the mixer Cleaning and care Troubleshooting Disposal Warranty & Service Importer Recommended filling quantities PAGE 2 2 3 3 3 3 4 4 5 6 7 7 8 8 8 9 Read these operating instructions carefully before using the appliance for the first time and preserve this maual for later reference. Pass this manual on to whoever might acquire the appliance at a future date. -1- FOOD PROCESSOR Safety Notices · · · Danger of electrical shock!Ensure that the power supply to be used tallies with the details on the model details plate. Ensure that the power cable never becomes wet or moist whilst in use. [. . . ] · Turn the rotary switch g to P and hold it firmly until the drive motor j comes to a standstill (Fig. · Press the unlocking button f down and raise the swivel arm h a little. · Press the unlocking button f down and bring the swivel arm h into operating position 4 (see chapter "Operating positions"). · Remove the accessories from the drive motor j. · Remove the mixing bowl y. · Clean all parts (see chapter "Cleaning and care"). Working with the food processor Note: Ensure that on the swivel arm h neither the kneading hooks q, the whisk e nor the mixing beater w are attached. Proceed as follows to prepare the appliance for operation with the food processor u: · Press the unlocking button f down and bring the swivel arm h into operating position 4 (see chapter "Operating positions") (Fig ). The base of the mixing bowl y must engage in the recesses k on the appliance. · Press the unlocking button f down and bring the swivel arm h into operating position 1 (see chapter "Operating positions"). · Remove the drive protection lid for the food processor u (Fig. · Insert the food processor u into the drive opening (The "dot" marking on the food processor u to the "arrow" marking on the swivel arm h) and then turn it clockwise as far as it will go (The "lock" marking on the food processor onto the "arrow" marking on the swivel arm h). · Depending on the task to be performed, place the cutting s, rasping o or rubbing i disc onto the drive shaft a of the food processor. · Place the lid with stodger d onto the food processor u and latch it down. · Set the rotary switch g to the desired level. Note: Do not press too many ingredients in the food processor u. Take note of the table in the chapter , , Recommended filling quantities". · Insert ingredients through the loading shaft with the stodger d. -5- Risk of injury from rotating parts!To avoid personal injury and damage to the appliance, NEVER insert or place your hands or foreign objects into the loading shaft. Only insert ingredients by use of the stodger. Only change accessories when the drive motor j is at standstill!After being switched off, the drive motor j continues to run for a short time. The appliance may only be used when the drive openings not being utilised are covered with drive protection lids. In cases of malfunction switch the appliance off and remove the plug from the wall socket, this will avoid an unintentional switching-on of the appliance. [. . . ] Arrange for the appliance to be repaired in a qualified specialist workshop or by customer services. -7- Disposal Do not dispose of the appliance in your normal domestic waste. This product is subject to the European guideline 2002/96/EC. Dispose of the appliance through an approved disposal centre or at your community waste facility. Observe the currently applicable regulations. [. . . ]