User manual SILVERCREST SLS 1000 A1

[. . . ] If the situation is not avoided it can lead to property damage. The directives in this warning are there to avoid property damage. This device is intended exclusively for power supply to devices that have an operating voltage of 5 V (mobile telephones, MP3 players, etc. Any other use or usage beyond those mentioned is considered improper use and can result in damages and injuries. [. . . ] Charging station SLS 1000 A1 Mains power supply unit NS120P180PGS 12 Plug-in connection cables for 5 V This operating manual NOTICE Check the contents to make sure everything is there and for visible damage. If the contents are not complete or are damaged as a result of defective packaging or through transportation contact the service hotline (see chapter Service). Remove all device parts and these operating instructions from the carton. The packaging materials are selected from the point of view of their environmental friendliness and disposal technology and are therefore recyclable. the recirculation of packaging into the material circuit saves on raw material and reduces generated waste. Dispose of packaging material that is no longer needed according to the regionally established regulations. Connection socket for power supply unit Connection socket for the adapter cable Connection socket for the adapter cable Connection socket for the adapter cable Connection socket for the adapter cable USB port Mains power supply unit Mains power supply unit operation LED Adapter cable Nokia large (MC01) Adapter cable Nokia small (MC28) This data must be compatible to avoid possible damage to the device. Make sure that the mains power supply unit's 8 cable is not damaged and does not run across hot surfaces and/or sharp edges, otherwise it will become damaged. Make sure that the mains power supply unit's knoted. Plug the mains power supply unit LED 9 lights up. Connect the mains power supply unit 8 to the charging station by inserting the plug into the connection socket 2 on the rear panel of the device. This information can be found in the device's operating instructions. Make sure that the maximum current consumption does not exceed 1000 mA (only when using the USB ports 7 ) and/or 2000 mA. This information can be found in the device's operating instructions. Remove the cover from the charging station and insert the plug of the applicable adapter cable in one of the connection sockets 3 - 6 and/or the iPod/iPhone cable 21 into the USB port 7 . Place the cover back on the charging station thereby feeding the adapter cable through the cut-out on the front panel of the cover. Plug the other end of the adapter cable into the device's power supply socket. The device now receives its power supply from the charging station. if the device has a charge control indicator , this will show that the device is charging. NOTICE The charging station is so efficient that all 4 connection sockets 3 the USB port 7 can be used at the same time. The following table will help with localizing and remedying minor malfunctions: Possible cause The voltage of the device is not compatible with the charging The connected station. Faulty connection between the charging The charging station and the mains station LED power supply unit 8 . [. . . ] The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorised service branch. Your statutory rights are not restricted in any way by this warranty. The warranty period is not extended by repairs made under the warranty. this applies also to replaced and repaired parts. [. . . ]