User manual SILVERCREST SND 3600 A2

[. . . ] The manufacturer assumes no responsibility for damage caused by failure to observe the instructions, improper use, inappropriate repairs, making unauthorized changes or for using unapproved replacement parts. In the current operation instructions the following warnings are used: WARNING A warning of this danger level signifies a possible dangerous situation. If the dangerous situation is not avoided it can lead to injuries. The directives in this warning are there to avoid personal injuries. [. . . ] You can find further information in the programme's on-line help. the illustrations and descriptions refer to the operating system Microsoft® Windows® 7. The illustration depictions can differ, depending on the display settings, with other operating systems. NOTICE If you have switched off the autostart function and the installation process does not begin automatically you can start the installation process by double clicking on the file "autorun. The computer recognizes the new hardware and starts the automatic driver installation. In this chapter you receive important information for the handling and operation of the device. Release the fastener on the front of the film holder 5 and open the holder. insert the film strip , correctly orientated , into the holder. Close the holder making sure that the cover locks into place. Place the slides, with the sides the right way round, into the intended slot of the slide magazine 6 . First guide the slide magazine 6 , with the viewing window leading, into the insert slot 3 . By means of the slider, located laterally on the slide magazine 6 , the slides contained in the slots are pushed individually into the scanner. For this, first slide the slider away from the scanner to the dead stop. Then carefully move the slider back towards the scanner. NOTICE A slide located in the scanner is thereby removed from the appliance and a new slide is pushed into the visual range of the scanner. Be sure to insert a new slide into the scanner slowly. If this happens too quickly, then the slide could glide outside the visual range of the scanner. In this case, you will need to raise the appliance slightly to the side, so that the slide can glide back to an optimal position. When you have decided to finish scanning the slides, remove the slide magazine 6 from the insert slot 3 . Remove the last slide from the bottom of the viewing window of the slide magazine 6 . Image editing tools: Detailed image editing NOTICE In these operating instructions only the programme sections are described that you will need for scanning your slides and/or film negatives. You can find further information in the programme's online help. [. . . ] In the case of a warranty claim, please get in touch, by telephone, with our service department. Only in this way can a post-free despatch for your goods be assured. NOTICE The warranty is valid only for material or manufacturing defects and not for transportation damage, wear and tear or for damages to breakable parts such as switches or power packs. This product is for private use only and is not intended for commercial applications. [. . . ]